首页|期刊导航|实验技术与管理|动车组脱落冰雪积块击打应答器损伤仿真及改进措施

动车组脱落冰雪积块击打应答器损伤仿真及改进措施OA

Damage simulation and improvement measures for balises struck by falling ice-snow accretions from high-speed EMUs

中文摘要英文摘要

应答器作为铁路信号列控系统的地面核心设备,在冰雪天气会遭遇动车组脱落冰雪积块击打受损,严重影响行车秩序.为精确表征应答器遭受冰雪击打时的力学特性并给出临界限速范围,研究改善措施,文章以应答器SMC-4/3394材料为研究对象,开展不同温度条件下的拉伸及冲击实验,获取材料应力-应变曲线、冲击强度等力学参数;实验结果表明,SMC-4/3394材料弹性模量受温度影响较小,冲击强度随温度降低显著提高.以此为基础,利用 ABAQUS 有限元分析软件建立冰雪积块击打应答器的动力学仿真模型,分析不同击打条件下的应答器的损伤规律.仿真结果显示,应答器损伤程度随击打速度升高而加剧,损坏临界速度在220 km/h左右.这一结论既支撑现有高铁运营限速设置值,也指出可优化的空间.此外,仿真研究给出了改善损坏问题的关键因素,一是降低应答器安装高度,既能减轻损伤程度,又能降低被击打概率;二是优化应答器侧面结构,在相同外部条件下,侧面斜角结构能够明显减轻应答器的损坏程度.总之,研究为冰雪天气下高铁运行限速提供了技术支撑,也为应答器运维和研发提供了有价值的指导.

[Objective]With the rapid expansion of China's high-speed railway(HSR)network across vast territories characterized by drastically varying climatic conditions,ensuring the operational reliability of railway signaling systems under extreme ice and snow conditions has emerged as a critical engineering challenge.During winter operations,the ice and snow chunks that accumulate on electric multiple unit bogies and underframes frequently detach during high-speed travel—particularly when trains cross the 0℃isotherm—causing high-energy impact damage to the wayside equipment.As the core ground device of the Chinese Train Control System,balises are vital for transmitting line parameters,positioning data,and temporary speed limit information to onboard equipment.Over 300 000 balise units are in service across China's HSR network,and their structural integrity directly determines railway operational safety and efficiency.Previous research on balise impact resistance has mostly neglected the influence of the low-temperature mechanical properties of housing materials,leading to significant deviations between the simulation results and field failure cases.Furthermore,systematic analyses of the damage phenomenon under ice-snow impact and targeted improvement measures are lacking.This study aimed to address these critical research gaps.[Methods]This study analyzed SMC-4/3394 sheet molding compound,which is the mainstream material for commercial balise housings.First,quasi-static tensile tests and Charpy impact tests were conducted at four temperatures(20℃,0℃,−10℃,and−20℃),representing the actual winter operating temperatures of China's HSR,to obtain key mechanical data,including full stress-strain curves,elastic modulus,yield strength,and impact strength.Based on these data,a refined full-scale explicit dynamic finite element(FE)model of ice-snow chunks impacting a balise(including the housing,mounting fixture,and ice block)was established using Abaqus software.The damage evolution behavior of the balise under different impact conditions was systematically analyzed over impact speeds of 160-350 km/h(the operating speed range of China's HSR)and at typical impact positions consistent with field failure data.Finally,parametric simulation studies were performed to identify the key optimization factors for mitigating balise damage.[Results]The material test results show that the elastic modulus of SMC-4/3394 is slightly affected by ambient temperature,whereas its impact strength exhibits a significant increasing trend with decreasing temperature,providing accurate and reliable input parameters for subsequent FE simulations.The FE simulation results indicate that the balise suffers an increasing degree of damage with increasing impact speed and that the critical speed for structural damage initiation is approximately 220 km/h.This conclusion verifies the rationality of existing winter speed limit regulations for the HSR network and clarifies the safety margin of train operations in icy and snowy weather.Furthermore,parametric simulation studies identified two key optimization factors:(1)appropriately reducing the installation height of the balise can significantly reduce the severity of structural damage under the same impact energy and lower the probability of it being hit by falling ice-snow chunks;(2)optimizing the side profile of the balise housing with a bevel structure can effectively reduce the peak stress of the housing,achieving a notable reduction in the damage degree compared with the original right-angle structure under identical working conditions.[Conclusions]This study reveals the damage mechanism of balises under ice-snow chunk impact by comprehensively considering low-temperature material properties,thereby filling a research gap in this field.The research results provide solid theoretical support for formulating science-informed winter operation speed limits for HSR in ice and snow conditions.Moreover,they offer valuable technical guidance for the daily maintenance,fault prevention,and structural optimization of balises.

高立中;邢群雁;赵阳;牛洪涛;李庠儒;张海翔

中国铁道科学研究院 通信信号研究所,北京 100081中国铁道科学研究院 通信信号研究所,北京 100081中国铁道科学研究院 通信信号研究所,北京 100081清华大学 航天航空学院,北京 100084清华大学 核能与新能源技术研究院,北京 100084清华大学 核能与新能源技术研究院,北京 100084

交通工程

应答器SMC-4/3394材料力学性能实验有限元仿真冰雪积块击打

baliseSMC-4/3394 materialmechanical property testfinite element simulationimpact by ice and snow chunks

《实验技术与管理》 2026 (10)

67-74,8

国铁集团系统性重大项目"冰雪灾害对铁路信号设备影响及应对措施研究"(P2024G002)

10.16791/j.cnki.sjg.2026.10.009

评论