破碎剂作用下切槽深度对混凝土断裂模式的影响OA
Effect of notch depth on the fracture mode of concrete under the action of soundless chemical demolition agents
静态破碎相对于传统爆破方式,其优点是安全、环保,在石材开采、致裂岩石和城市建筑物拆除工程中得到广泛应用,然而该技术在定向破碎方面研究不足,存在致裂时间长、破碎方向不易预测和控制等问题.为探究膨胀荷载下不同切槽深度对试样断裂效果的影响,开展了5组不同切槽深度的混凝土试块静态破碎试验,结合声发射、应变监测和数字图像相关(digital image correlation,简称DIC)技术研究膨胀荷载作用下切槽深度对试样断裂模式的影响规律,讨论了切槽试样在不同破碎阶段的能量特征、应变特征与表面应变场的变化规律.在试验中观察到两种裂纹类型:P型裂纹(裂纹平行于切槽方向扩展)和T型裂纹(裂纹垂直于切槽方向扩展).结果显示,与圆孔试样相比,两翼切槽孔试样的起裂时间缩短了约1 h,且切槽深度越大,起裂时间越短;随着切槽深度的增加,试样的最终断裂模式由P-P-T-T向P-P转变,切槽深度的增加将使得切槽处应力集中增强,进而抑制T型裂纹的产生;在P-P-T-T和P-P-T断裂模式中,T型裂纹萌生会导致其对应自由面的应变由上升趋势转为下降趋势,形成了明显的受力状态转折点;P型裂纹开裂时,试样的声发射撞击数和能量均急剧上升,P-P-T-T和P-P-T断裂模式的撞击数、累积能量均高于P-P断裂模式,且T型裂纹萌生会导致撞击数产生第二段峰值.
Compared with traditional blasting methods,static cracking is safer and more environmentally friendly and has been widely used in stone quarrying,rock fracturing,and urban building demolition.However,research on its directional fracture performance remain limited.Challenges such as long crack initiation times and poor predictability and controllability of fracture propagation direction persist.To investigate the influence of notch depth on the fracture behavior of specimens under expansive loading,five groups of static cracking tests were conducted on concrete specimens with different notch depths.Acoustic emission(AE),strain monitoring,and digital image correlation(DIC)were combined to examine the effects of notch depth on fracture modes under expansive loading.The evolution of energy characteristics,strain characteristics,and surface strain fields at different failure stages was also analyzed.Two types of cracks were observed during the tests:P-type cracks,which propagated parallel to the slot direction,and T-type cracks,which propagated perpendicular to it.The results show that,compared with circular-hole specimens,double-wing slotted-hole specimens exhibited crack initiation approximately 1 h earlier.In addition,greater notch depths led to earlier crack initiation.As notch depth increased,the final fracture mode gradually shifted from P-P-T-T to P-P,indicating that deeper notches enhanced stress concentration at the slot and thereby suppressed the formation of T-type cracks.In the P-P-T-T and P-P-T fracture modes,the initiation of T-type cracks caused the strain on the corresponding free surface to change from an increasing to a decreasing trend,producing a distinct turning point in the stress state.When P-type cracks initiated,both the AE hit count and cumulative energy increased sharply.Moreover,the AE hit count and cumulative energy were higher in the P-P-T-T and P-P-T fracture modes than in the P-P mode.In addition,the initiation of T-type cracks produced a second peak in the AE hit count.
张永杰;李荣津;王宇;孙栋良;陈璐;徐鸿;何博凡
长沙理工大学土木与环境工程学院,湖南长沙 410114长沙理工大学土木与环境工程学院,湖南长沙 410114长沙理工大学土木与环境工程学院,湖南长沙 410114长沙理工大学土木与环境工程学院,湖南长沙 410114长沙理工大学土木与环境工程学院,湖南长沙 410114长沙理工大学土木与环境工程学院,湖南长沙 410114长沙理工大学土木与环境工程学院,湖南长沙 410114
建筑与水利
静态破碎切槽深度膨胀荷载断裂模式
static crackingnotch depthexpansion loadfracture mode
《岩土力学》 2026 (9)
3091-3101,11
国家自然科学基金(No.52478440,No.52408414,No.52004036).This work was supported by the National Natural Science Foundation of China(52478440,52408414,52004036).
评论