低阻高效板式换热器板片端面形状优化研究OA
Optimization of End-Face Shape for Low-Resistance and High-Efficiency Plate Heat Exchanger Plates
针对钎焊式板式换热器降低水侧流阻会导致传热性能降低的问题,本文提出一种新型锯齿形低齿端面波纹结构.该结构通过在波纹端面设置锯齿与沟槽,在扩大流通面积的同时增强流体扰动.仿真优化了 3种齿形参数并确定最优结构,通过实验验证该最优结构效果.结果表明:仿真与实验数据的相对误差小于 3%;在多种流量工况下,最优样件的综合性能较原型提升了 9.06%~16.67%,实现了在保证换热能力满足要求的情况下尽可能降低压降.
To address the trade-off where the reduction of water-side flow resistance compromises heat transfer performance in brazed plate heat exchangers,a new sawtooth low-tooth corrugation structure is proposed in this paper.By the incorporation of saw teeth and grooves on the corrugation end-face,the flow area is enlarged by this design,while fluid disturbance is simultaneously enhanced.Three tooth profiles are optimized via simulation to determine the optimal structure,which is subsequently validated through experiments.It is indicated by the results that a relative error of less than 3%exists between simulation and experimental data.Under various flow conditions,the comprehensive performance of the optimized prototype is increased by 9.06%–16.67%compared to the original design,and the pressure drop was effectively minimized while the satisfaction of heat transfer requirements is ensured.
韦昊廷;庄大伟;丁国良;陈君奕;施吉璐;王典运
上海交通大学机械与动力工程学院,上海 200240上海交通大学机械与动力工程学院,上海 200240上海交通大学机械与动力工程学院,上海 200240江苏唯益换热器有限公司,江苏 镇江 212311江苏唯益换热器有限公司,江苏 镇江 212311江苏唯益换热器有限公司,江苏 镇江 212311
通用工业技术
钎焊板式换热器端面形状优化设计低流阻
Brazed plate heat exchangerTransverse structureOptimized designLow flow resistance
《制冷技术》 2026 (3)
46-52,7
评论