首页|期刊导航|制冷技术|超流氦管内流动传热仿真模型及温度分布特性分析

超流氦管内流动传热仿真模型及温度分布特性分析OA

Simulation Model of Flow and Heat Transfer in Superfluid Helium Pipes and Analysis of Temperature Distribution Characteristics

中文摘要英文摘要

本文基于一维超流氦传热模型,利用MATLAB软件求解管道中点加热与端部加热条件下稳态和瞬态一维超流氦无量纲传热方程.通过与前人文献中的实验数据对比,验证了方程计算结果的可靠性.本文计算了稳态条件下不同热流密度、冷端温度及流速下的一维超流氦的无量纲温度分布.结果表明:随着端部热流密度增加,超流氦内部温度升高幅度逐渐减小,当热流密度超过 30 W/cm2 时,超流氦内部温度差异较小.随后,研究了网格数与时间步长对瞬态计算结果的影响,并对3 种工况分别进行了稳态和瞬态计算,结果十分接近,进一步验证了瞬态计算方法的准确性.

In this study,a one-dimensional superfluid helium heat transfer model is applied,and the steady-state and transient dimensionless heat transfer equations are solved under midpoint and end-point heating conditions using MATLAB software.The reliability of the numerical results is validated by comparing them with experimental data from previous studies.The dimensionless temperature distribution of one-dimensional superfluid helium is computed under steady-state conditions for various heat flux densities,cold-end temperatures,and flow velocities.The results show that as the heat flux density at the end increases,the temperature rise within the superfluid helium gradually decreases.When the heat flux density exceeds 30 W/cm²,the internal temperature difference of the superfluid helium is not significant.Furthermore,the influence of grid number and time step size on the transient results is investigated.Steady-state and transient calculations are performed for three different operating conditions,with results showing close agreement,further validating the accuracy of the transient calculation method.

赵佳思;徐洪波;彭楠;李正宇

低温科学与技术重点实验室,北京 100190||中国科学院大学,北京 100049||中国科学院理化技术研究所,北京 100190低温科学与技术重点实验室,北京 100190||中国科学院理化技术研究所,北京 100190低温科学与技术重点实验室,北京 100190||中国科学院理化技术研究所,北京 100190低温科学与技术重点实验室,北京 100190||中国科学院理化技术研究所,北京 100190

通用工业技术

超流氦端部加热数值求解无量纲温度

Superfluid heliumEnd heatingNumerical solutionDimensionless temperature

《制冷技术》 2026 (3)

37-45,9

中国科学院稳定支持基础研究领域青年团队计划(No.YSBR-017).

10.3969/j.issn.2095-4468.2026.03.106

评论