首页|期刊导航|江西建材|不同龄期下砂浆黏结强度检测结果的演变规律及验收标准探讨

不同龄期下砂浆黏结强度检测结果的演变规律及验收标准探讨OA

Discussion on the Evolution Law of Mortar Bonding Strength and Acceptance Standards at Different Ages

中文摘要英文摘要

为探明砂浆黏结强度随龄期的演变规律并评估早期验收可行性,文中设计 A-M5、A-M10 普通砌筑砂浆与 B-M20、B-M30 聚合物改性砂浆4 组配合比,测试3、7、14、28、60 d 龄期的黏结强度.结果表明,4 组砂浆黏结强度均随龄期延长而提高,60 d 强度较28 d仅增加4%~7%,后期增长幅度有限.聚合物改性可显著加快早期强度发展,B-M30 在3d 时的黏结强度(0.50 MPa)已超过 A-M10在28 d 的实测值.7 d 与28 d 强度呈高度相关,可用于后期强度推算.普通砂浆 3~7 d 强度增长率为 54%,而改性砂浆同期仅为30%,两者分别表现出"低基数持续增长"与"早期高强度后趋于稳定"的差异化发展模式.胶凝材料用量从210 kg/m3 增至380 kg/m3时,28 d 强度由0.27 MPa 升至0.73 MPa.建议普通砂浆7d 强度≥0.17 MPa 条件通过,改性砂浆≥0.47 MPa 直接验收.

To explore the evolution law of mortar bonding strength with age and evaluate the feasibility of early acceptance,four mix ratios of ordinary masonry mortar A-M5 and B-M20,B-M30 polymer-modified mortar were designed.The bonding strength was tested at five ages:3 d,7 d,14 d,28 d and 60 d.The test results show that the bonding strength of all four mortars increases with the extension of age,and the strength at 60 d is only 4%to 7%higher than that at 28 d.The growth rate in the later stage is limited.Polymer modification can significantly accelerate the development rate of early strength.The bonding strength of B-M30 at 3 d(0.50 MPa)is already higher than the measured value of A-M10 at 28 d.There is a high correlation between the 7 d and 28 d strengths,which can be used for later strength estimation.The strength growth rate of ordinary mortar in the age range of 3 d to 7 d is 54%,while that of modified mortar is only 30%.They respectively exhibit a differentiated development pattern of"low base and continuous growth"and"high early strength followed by stability".When the cementitious material dosage increases from 210 kg/m3 to 380 kg/m3,the 28 d strength increases from 0.27 MPa to 0.73 MPa.It is recommended that the 7 d strength of ordinary mortar should be≥0.17 MPa for acceptance,and the modified mortar should be≥0.47 MPa for direct acceptance.

曾拥军

深圳市港嘉工程检测有限公司,广东 深圳 518126

建筑与水利

砂浆黏结强度龄期演变规律验收标准聚合物改性

MortarBonding strengthAgeEvolution lawAcceptance standardsPolymer modification

《江西建材》 2026 (7)

34-36,45,4

评论