首页|期刊导航|高压物理学报|基于FDEM的含铜钠长岩冲击破裂过程与能量耗散特征研究

基于FDEM的含铜钠长岩冲击破裂过程与能量耗散特征研究OA

Impact-Induced Fracture Process and Energy Dissipation Characteristics of Copper-Bearing Albite Rock Based on FDEM

中文摘要英文摘要

为了保证铜矿资源的高效回采,以含铜钠长岩试样为研究对象,使用分离式霍普金森压杆施加不同强度的冲击荷载,利用高速摄像系统记录裂纹扩展过程,并结合一维应力波传播理论和能量守恒定律,分析试样在不同冲击气压下的能量耗散规律;同时,基于有限-离散元耦合算法,建立含铜钠长岩冲击过程的数值模型.结果表明:入射能和应力峰值随着冲击气压的增大而增大,试样破碎程度也随之加剧;当入射能小于 140 J 时,随着入射能的增大,能量耗散率逐渐增大;当入射能大于 140 J 时,能量耗散率随入射能的增加逐渐减小,能量耗散率在冲击气压为 0.35 MPa 时最大;在冲击过程中,拉伸破坏占主导作用,并在水平方向形成主优势区.新增裂纹面积和冲击总能量随着冲击荷载的增加而增大;冲击气压为 0.30 MPa 时,应变能比能量最小,在此气压下,剪切裂纹占比最小,说明 0.30 MPa 冲击气压的破岩效率最高;基于有限-离散元构建的数值模型可以有效预测在不同冲击荷载下含铜钠长岩的损伤破裂过程.

In order to ensure the efficient recovery of copper resources,the copper-bearing albite rock samples were taken as the research object,and the impact loads with different strengths were applied by the split Hopkinson pressure bar(SHPB).The crack propagation process was recorded by a high-speed camera system,and the energy dissipation law of the samples under different impact pressures was analyzed by combining the one-dimensional stress wave propagation theory and the law of conservation of energy.At the same time,a numerical model of the impact process of copper-bearing albite is established based on the finite-discrete element coupling algorithm.The results show that the incident energy and the peak stress increase with the increase of the impact gas pressure,and the degree of sample breakage also increases.When the incident energy is less than 140 J,the energy dissipation rate increases with the increase of the incident energy.When the incident energy is greater than 140 J,the energy dissipation rate decreases with the increase of the incident energy,and the energy dissipation rate reaches the maximum when the impact gas pressure is 0.35 MPa.In the process of impact,tensile failure plays a dominant role and forms the main dominant area in the horizontal direction.The new crack area and the total impact energy increase with the increase of impact load.When the impact gas pressure is 0.30 MPa,the strain energy ratio is the smallest.Under this pressure,the proportion of shear cracks is the smallest,indicating that the rock breaking efficiency of 0.30 MPa impact gas pressure is the highest.The numerical model based on finite-discrete element method can effectively predict the damage and fracture process of copper-bearing albite under different impact loads.

张熙远;李祥龙;左庭;刘金保;王建国;胡涛;王浩

昆明理工大学国土资源工程学院,云南 昆明 650093昆明理工大学国土资源工程学院,云南 昆明 650093||云南省教育厅爆破新技术工程研究中心,云南 昆明 650093昆明理工大学国土资源工程学院,云南 昆明 650093云南磷化集团有限公司,云南 昆明 650600昆明理工大学国土资源工程学院,云南 昆明 650093||云南省教育厅爆破新技术工程研究中心,云南 昆明 650093昆明理工大学国土资源工程学院,云南 昆明 650093昆明理工大学国土资源工程学院,云南 昆明 650093

数理科学

分离式霍普金森压杆裂纹演化能量分析有限-离散元方法

split Hopkinson pressure barcrack evolutionenergy analysisfinite-discrete element method

《高压物理学报》 2026 (10)

63-80,18

国家自然科学基金(52274083)云南省重大科技专项(202202AG050014)云南省基础研究计划(202201AT070178)

10.11858/gywlxb.20251198

评论