功率器件封装中电沉积铜阵列形貌与应用的研究OA
Morphology and Application of Electrodeposited Copper Arrays in Power Device Packaging
为提高功率器件封装中Cu-Cu直接键合界面的低温连接质量,采用双连续微乳液电沉积法制备不同形貌的铜阵列,研究沉积电压和铜盐浓度对阵列形貌及键合性能的影响.结果表明,随着沉积电压或铜盐浓度升高,铜沉积形貌由连续薄层逐步演化为颗粒状、柱状团聚和枝晶结构,表面粗糙度与孔隙率同步增大.其键合强度受孔隙连通性、界面连续性和结构互锁程度的共同控制.在260 ℃、10MPa、15 min的热压键合条件下,柱状团聚阵列界面连续性较好,且压溃互锁明显,因此强度最高;颗粒化阵列易形成连通未键合带,在3种铜阵列中强度最低;枝晶阵列则受高孔隙率和局部低致密区限制,表现为中等强度.
To improve the low-temperature bonding quality at the Cu-Cu direct bonding interface in power device packaging,Cu arrays with different morphologies are prepared using a bicontinuous microemulsion electrodeposition method.The effects of deposition voltage and Cu salt concentration on the array morphology and bonding performance are investigated.It is found that as the deposition voltage or Cu salt concentration increases,the Cu deposition morphology gradually evolves from a continuous thin layer to granular,columnar-agglomerate,and dendritic structures,accompanied by a simultaneous increase in both surface roughness and porosity.The bonding strength is primarily governed by the combined effects of pore connectivity,interfacial continuity,and the degree of structural interlocking.Under hot-press bonding conditions of 260℃,10 MPa,and 15 min,the columnar-agglomerate array exhibits good interfacial continuity and significant crushing-induced interlocking,resulting in the highest strength;the granular array is prone to forming interconnected unbonded zones,and consequently exhibits the lowest strength among the three Cu arrays;the dendritic array,constrained by high porosity and localized low-density zones,exhibits moderate strength.
张艺豪;张景辉;王奉祎;江贤达;陈宏涛
哈尔滨工业大学(深圳)集成电路学院,广东 深圳 518055哈尔滨工业大学(深圳)集成电路学院,广东 深圳 518055哈尔滨工业大学(深圳)集成电路学院,广东 深圳 518055哈尔滨工业大学(深圳)集成电路学院,广东 深圳 518055哈尔滨工业大学(深圳)集成电路学院,广东 深圳 518055
信息技术与安全科学
铜阵列电沉积Cu-Cu直接键合剪切强度
Cu arrayelectrodepositionCu-Cu direct bondingshear strength
《电子与封装》 2026 (9)
41-47,7
评论