首页|期刊导航|电子与封装|抑制剂分子结构对电沉积铜镀层电学性能的影响

抑制剂分子结构对电沉积铜镀层电学性能的影响OA

Effect of Inhibitor Molecular Structure on the Electrical Properties of Electrodeposited Copper Plating

中文摘要英文摘要

考察了线性聚乙二醇(PEG)、芳香族空间位阻型抑制剂(NP-40)以及环氧乙烷-环氧丙烷嵌段共聚物(EO-PO)3种分子量相同但分子结构不同的非离子抑制剂.电化学分析结果表明,尽管在不添加加速剂SPS的情况下各组分的极化行为相似,但在共添加SPS的条件下极化行为出现显著差异,CV曲线结果表明,抑制剂极化能力由强到弱分别为NP-40、EO-PO、PEG.进一步对在抑制剂与SPS共存条件下制备的铜镀层进行了微观组织表征、杂质测试和电学性能测试.EO-PO样品对应镀层具有相对较小的平均晶粒尺寸,同时表现出较大的电阻率和较高的杂质含量;经过150 ℃退火后该镀层出现显著的晶粒长大现象,这一现象应该源于细晶组织具备的较高的晶粒生长驱动力,其作用强度远超杂质元素的晶界钉扎效应,使得杂质的钉扎作用被掩盖.但值得注意的是,在退火过程的电阻率演变规律中,杂质元素仍是不可忽略的重要控制因素.相比之下,NP-40样品在具有最佳抑制能力的同时还能保持相对较低的电阻率和杂质残留.这些发现为合理设计用于先进铜互连电沉积的抑制剂提供了理论基础,有助于提高铜镀层的电学性能.

Three nonionic inhibitors,namely linear polyethylene glycol(PEG),an aromatic sterically hindered inhibitor(NP-40),and an ethylene oxide-propylene oxide block copolymer(EO-PO),with the same molecular weight but different molecular structures are investigated.The electrochemical analysis shows that although the polarization behavior of each component is similar without the addition of accelerator SPS,significant differences in polarization behavior occur under the condition of co-addition of SPS.The CV curves show that the inhibitors are ranked in descending order of polarization ability as follows:NP-40,EO-PO,and PEG.Microstructure characterization,impurity testing,and electrical property testing are further performed on the copper coatings prepared under the coexistence of inhibitors and SPS.The EO-PO sample exhibits a relatively small average grain size and a high resistivity and elevated impurity content.After annealing at 150℃,a remarkable grain growth is observed in this sample,which can be attributed to the high grain growth driving force inherent in the fine-grained microstructure.The intensity of this driving force far exceeds the grain boundary pinning effect of impurity elements,thus masking the pinning effect of impurities.However,impurity elements remain a significant and non-negligible controlling factor in resistivity evolution during the annealing process.In contrast,the NP-40 sample not only demonstrates the optimal inhibition capacity but also maintains a relatively low electrical resistivity and minimal impurity residue.These findings provide a theoretical basis for the rational design of inhibitors for advanced copper interconnect electrodeposition,thereby improving the electrical properties of copper plating.

张耿华;高丽茵;曾方元;刘志权

中国科学院深圳先进技术研究院,广东 深圳 518055||中国科学院大学,北京 100049中国科学院深圳先进技术研究院,广东 深圳 518055||中国科学院大学,北京 100049中国科学院深圳先进技术研究院,广东 深圳 518055南方科技大学半导体学院(国家卓越工程师学院),广东 深圳 518055

信息技术与安全科学

抑制剂电镀铜微观组织杂质电学性能

inhibitorelectroplated coppermicrostructureimpuritieselectrical property

《电子与封装》 2026 (9)

24-32,9

国家自然科学基金(92373208、62574212)

10.16257/j.cnki.1681-1070.2026.0117

评论