首页|期刊导航|电源学报|用于电磁轴承驱动的软开关功率放大器

用于电磁轴承驱动的软开关功率放大器OA

Soft Switching Power Amplifier for Electromagnetic Bearing Drive

中文摘要英文摘要

传统的电磁轴承功率放大器通常采用电路结构简单、实用性较高的硬开关电路拓扑,但存在开关管的开关损耗大、易过热损坏的问题,同时限制了其在更高工作频率场景的使用,且在较高母线电压、较高开关频率条件下,会产生严重的电磁噪声.针对硬开关功率放大器在工作中存在的各种缺陷,提出一种适用于电磁轴承系统的软开关功率放大器,并详细分析了其电路拓扑的工作原理.通过仿真和实验进行对比分析,结果表明,该拓扑在满足功率放大器基本性能要求的情况下,能降低开关损耗,抑制高频工作状态下的电磁噪声,提高系统的工作效率.

The traditional electromagnetic bearing power amplifier usually adopts the hard switching circuit topology with simple circuit structure and high practicability,but it has the problems of large switching loss and easy overheating damage of the switch tube,which limits the use scenarios at higher operating frequencies,and will produce serious electromagnetic noise at higher bus voltage and higher switching frequency.Aiming at the defects of hard switching power amplifier in operation,a soft switching power amplifier suitable for electromagnetic bearing system is proposed,and the working principle of the circuit topology is analyzed in detail.Through the comparative analysis of simulation and experiment,the results show that the topology can reduce the switching loss,reduce the electromagnetic noise in the high frequency working state and improve the working efficiency of the system under the condition of meeting the basic performance requirements of the power amplifier.

黄志勇;陈亮亮;靳晓光;伍家驹;王华

南昌航空大学信息工程学院,南昌 330063南昌航空大学信息工程学院,南昌 330063南昌航空大学信息工程学院,南昌 330063南昌航空大学信息工程学院,南昌 330063南昌航空大学信息工程学院,南昌 330063

信息技术与安全科学

电磁轴承功率放大器软开关开关损耗

Electromagnetic bearingpower amplifiersoft switchingswitching loss

《电源学报》 2026 (9)

22-31,10

国家自然科学基金资助项目(12062014,51967015)江西省自然科学基金资助项目(20202BABL204048)This work is supported by National Natural Science Foundation of China under the grants 12062014 and 51967015the Jiangxi Provincial Natural Science Foundation under the grant 20202BABL204048

10.13234/j.issn.2095-2805.2026.9.22

评论