首页|期刊导航|电力科技与环保|基于CFD的生物质气耦合燃煤锅炉低负荷稳定性研究

基于CFD的生物质气耦合燃煤锅炉低负荷稳定性研究OA

Research on low-load stability of biomass gas-coupled coal-fired boiler based on CFD

中文摘要英文摘要

[目的]为评估低负荷工况下燃煤耦合生物质气锅炉的流动与燃烧稳定性,为火电机组灵活调节提供依据.[方法]本文建立了640 MW超临界四角切圆锅炉的计算流体力学模型,开展不同负荷、不同掺烧比工况的研究.设置负荷为70%、50%、30%三种工况,每种负荷下设置生物质气掺烧比为5%、10%、15%、25%.依据四角切圆锅炉的流动特征,构建稳定性系数,并结合速度场、温度场、着火温度、着火距离、温度分布及烟气排放浓度等指标,综合评估各工况下的流动与燃烧稳定性.[结果]结果表明,在70%和50%负荷条件下,随着掺烧比例增加,稳定性系数变化幅度较小,炉内流动结构和温度场对称均匀,系统稳定性良好;在30%负荷条件下,掺烧比10%时系统稳定性显著下降,速度与温度稳定性系数偏差达到61.53%和10.19%;掺烧比提高后,稳定性有所改善,但仍弱于中高负荷工况.掺烧比例的增加可降低煤粉着火温度与着火距离,增强燃烧强度,提升炉内温度水平.排放浓度方面,生物质气掺烧可有效降低各工况下炉膛出口CO2和NOx 排放浓度,相对纯煤工况,最大降幅分别为26.98%和50.6%.[结论]因此,适当提高掺烧比例有助于改善低负荷下的燃烧稳定性与污染物排放水平.

[Objective]To evaluate the flow and combustion stability of a coal-fired boiler coupled with biomass gas under low-load conditions,and to provide a basis for flexible regulation of thermal power units.[Methods]A Computational Fluid Dynamics(CFD)model of a 640 MW supercritical tangential firing boiler was established,and studies under different loads and different co-firing ratios were conducted.A series of steady-state simulations were conducted under multiple load conditions(70%,50%,30%),each with biomass gas co-firing ratios of 5%,10%,15%and 25%.According to the theoretical flow characteristics of tangentially fired boilers,stability coefficients were constructed and used in combination with velocity field,temperature field,ignition temperature,ignition distance,temperature distribution,and flue gas emissions to comprehensively evaluate the stability of each operating condition.[Results]The results show that under 70%and 50%load conditions,the variation in stability coefficients with increasing co-firing ratio was small,and the internal flow structure and combustion field remained symmetrical and uniform,indicating good system stability.Under the 30%load condition,significant instability occurred when the co-firing ratio was 10%,with deviations in velocity and temperature stability coefficients reaching 61.53%and 10.19%,respectively.Further increases in the co-firing ratio led to some improvement in stability,but performance remained inferior to that under medium and high loads.Increasing the co-firing ratio reduced the ignition temperature and ignition distance of pulverized coal,enhanced combustion intensity,and elevated furnace temperature,with the most pronounced temperature rise observed at 30%load.In terms of emissions,co-firing biomass gas effectively reduced CO2 and NOx concentrations at the furnace outlet across all operating conditions,with maximum reductions of 26.98%and 50.6%,respectively.[Conclusion]These findings indicate that appropriately increasing the co-firing ratio can improve combustion stability and emission performance under low-load conditions.

赵钧;汪家军;李涛;刘三举;龚勋

华电湖北发电有限公司,湖北 武汉 430061华电湖北发电有限公司,湖北 武汉 430061煤燃烧与低碳利用全国重点实验室(华中科技大学能源与动力工程学院),湖北 武汉 430074华电湖北发电有限公司,湖北 武汉 430061煤燃烧与低碳利用全国重点实验室(华中科技大学能源与动力工程学院),湖北 武汉 430074

能源科技

生物质掺烧低负荷稳定性数值模拟

biomassco-firinglow loadstabilitynumerical simulation

《电力科技与环保》 2026 (4)

562-573,12

生物质气化耦合发电技术综合研究与应用(CHDKJ23-02-79)

10.19944/j.eptep.1674-8069.2026.04.005

评论