首页|期刊导航|安全、健康和环境|基于CFD模拟的抗爆墙高度对爆炸超压影响研究

基于CFD模拟的抗爆墙高度对爆炸超压影响研究OA

Research on the Impact of Blast Wall Height on Explosion Overpressure Based on CFD Simulation

中文摘要英文摘要

在既有建筑抗爆改造项目中,存在受建筑物结构和周边地形环境的影响、需要采用抗爆墙方案的场景,后果评估法与风险评估法通常采用二维模拟计算的方式进行,二维模拟对有复杂地形及遮挡物的场景模拟还原度较差,因此规范中指出当周边地形复杂,且严重影响气体扩散计算结果时,应收集三维地形数据,并采用可支持三维模拟的计算方法如计算流体动力学(Computational Fluid Dynamics,CFD)或气体扩散试验评估扩散影响.以某石油化工抗爆改造项目中抗爆墙方案为例,通过模拟计算结果可知在无抗爆墙场景下目标建筑物受爆炸超压 13.90 kPa,作用时间 96.0 ms.使用 FLACS 三维分析可以模拟分析不同墙高设置对爆炸冲击波的阻挡效果,经模拟得出:当防护目标固定人数小于 30 人时考虑经济成本选用4.0 m 高度即可,此高度下目标建筑物受爆炸超压 6.34 kPa,作用时间 44.5 ms;当防护目标固定人数超过30 人时可考虑选用8.0 m 墙高方案,在此高度下爆炸超压小于 3.00 kPa,可满足规范要求.由此证明通过 CFD 三维模拟可以从防护效果、高度和成本等角度选择最优抗爆墙高度方案作为设计方案基础,为后续结构计算提供理论支撑.

In blast-resistant renovation projects for existing buildings,blast wall solutions are required for scenarios constrained by building structures and surrounding topographic environments.Consequence assessment and risk assessment methodologies commonly employ two-dimensional simulation calculations;however,two-di-mensional simulation exhibits poor fidelity for scenarios featuring complex terrain and obstacles.Consequently,relevant standards specify that when complex surrounding terrain significantly affects gas dispersion calculation results,three-dimensional topographic data should be collected,and calculation methods supporting three-di-mensional simulation—such as computational fluid dynamics(CFD)or gas dispersion tests—should be adopted to evaluate dispersion impacts.Taking a blast wall scheme in a petrochemical blast-resistant renovation project as a case study,simulation results indicated that in the absence of a blast wall,the target building was subjected to an explosion overpressure of 13.90 kPa with a duration of 96.0 ms.FLACS three-dimensional simulation was utilized to model the blocking effects of different wall heights on explosion shock waves.The simulation out-comes suggested that when the number of permanent personnel for the protected target was fewer than 30,a wall height of 4.0 m was economically viable;at this height,the target building experienced an explosion overpres-sure of 6.34 kPa and a duration of 44.5 ms.When the number of permanent personnel exceeded 30,an 8.0 m wall height scheme could be considered,under which the explosion overpressure is less than 3.00 kPa,satisfy-ing standard requirements.This demonstrates that three-dimensional CFD simulation enables the selection of an optimal blast wall height scheme by balancing protection effectiveness,height,and cost,thereby providing a theoretical foundation for subsequent structural calculations.

万彦辰

应急管理部化学品登记中心,山东 青岛 266104||中石化国家石化项目风险评估技术中心有限公司,山东 青岛 266104

资源环境

抗爆墙CFD爆炸模拟防护目标建筑物抗爆加固

blast wallCFD methodexplosion simulationprotection of target buildingblast reinforce-ment

《安全、健康和环境》 2026 (9)

19-24,6

中国石化科技部项目(325067),石化典型烃类气燃爆抑制与装置高风险区爆炸荷载消减技术.

10.3969/j.issn.1672-7932.2026.09.003

评论