首页|期刊导航|中国造纸学报|分级多孔木材衍生炭基电催化剂的构筑及其析氢性能研究

分级多孔木材衍生炭基电催化剂的构筑及其析氢性能研究OA

Study on Fabrication of Wood-derived Carbon Electrocatalysts with Hierarchical Porous Structure and Its Hydrogen Evolution Performance

中文摘要英文摘要

本研究以天然松木为碳源,采用ZnCl2模板法结合KOH活化法的一步造孔策略,构筑了负载镍(Ni)核-镍钴合金(NiCo)壳结构的分级多孔木材衍生炭基电催化剂(Ni@NiCo-PCW).研究表明,ZnCl2溶液物质的量浓度在分级多孔结构的调控中起关键作用;在ZnCl2溶液物质的量浓度0.5 mol/L与KOH溶液物质的量浓度0.1 mol/L的最优造孔条件下,成功构筑了贯通的大孔-介孔-微孔分级多孔体系.得益于高比表面积带来的活性位点充分暴露、分级多孔结构赋予的快速气液传质速率,以及均匀分布的催化活性位点,在此条件下制备的Ni@NiCo-PCW-0.5在碱性和中性电解液中均展现出优异的析氢反应活性,在电流密度-10 mA/cm2下的电位分别为-14.11和-39.03 mV.同时,Ni@NiCo-PCW-0.5能够在电流密度-1 000(碱性)及-200 mA/cm2(中性)下稳定运行168 h.

In this study,using natural pine wood as the carbon source,a one-step pore-formation strategy combining ZnCl2 templating with KOH activation was employed to construct a hierarchical porous wood-derived carbon electrocatalyst(Ni@NiCo-PCW)featuring a nickel(Ni)core and a nickel-cobalt(NiCo)shell structure.The results demonstrated that ZnCl2 solution molar concentration played a key role in regulating the hierarchical porous structure.Under the optimum pore-forming conditions of ZnCl2 solution with molar concentration of 0.5 mol/L and KOH solution with molar concentration of 0.1 mol/L,a well-connected hierarchical porous system of macro-,meso-,and micro-pores was success-fully constructed.Owing to the ample exposure of active sites resulting from the high specific surface area,the rapid gas-liquid mass transfer rate afforded by the hierarchical porous structure,and the uniformly distributed catalyst active sites,Ni@NiCo-PCW-0.5 fabricated under this con-dition exhibited outstanding HER activity in both alkaline and neutral electrolytes,with potentials of only-14.11 mV and-39.03 mV at a current density of-10 mA/cm2,respectively.Meanwhile,Ni@NiCo-PCW-0.5 could operate stably for 168 h at current densities of-1 000 mA/cm2(alkaline electrolyte)and-200 mA/cm2(neutral electrolyte).

曹欣雨;李佳蔚;李镰岑;张如玉;许以昊;路家兴;王国容;姚远;钱光付

广西大学轻工与食品工程学院,广西 南宁,530004||广西清洁化制浆造纸及污染控制重点实验室,广西 南宁,530004广西大学轻工与食品工程学院,广西 南宁,530004||广西清洁化制浆造纸及污染控制重点实验室,广西 南宁,530004广西大学轻工与食品工程学院,广西 南宁,530004||广西清洁化制浆造纸及污染控制重点实验室,广西 南宁,530004广西大学轻工与食品工程学院,广西 南宁,530004||广西清洁化制浆造纸及污染控制重点实验室,广西 南宁,530004广西大学轻工与食品工程学院,广西 南宁,530004||广西清洁化制浆造纸及污染控制重点实验室,广西 南宁,530004广西大学轻工与食品工程学院,广西 南宁,530004||广西清洁化制浆造纸及污染控制重点实验室,广西 南宁,530004广西大学轻工与食品工程学院,广西 南宁,530004||广西清洁化制浆造纸及污染控制重点实验室,广西 南宁,530004广西大学轻工与食品工程学院,广西 南宁,530004||广西清洁化制浆造纸及污染控制重点实验室,广西 南宁,530004广西大学轻工与食品工程学院,广西 南宁,530004||广西清洁化制浆造纸及污染控制重点实验室,广西 南宁,530004

轻工纺织

木材衍生炭分级多孔结构模板法-活化法协同造孔核壳结构析氢反应

wood-derived carbonhierarchical porous structuretemplating-activation synergistic pore-formationcore-shell structurehydrogen evolution reaction

《中国造纸学报》 2026 (3)

207-220,14

广西自然科学基金(2025GXNSFAA069629,2024GXNSFBA010252)广西清洁纸浆与造纸及污染控制重点实验室开放项目(2022GXZZKF75).

10.11981/j.issn.1000-6842.2026.03.207

评论