首页|期刊导航|低碳化学与化工|Fe掺杂ZnCo-DMC催化CO2/PO共聚制备聚醚碳酸酯多元醇性能研究

Fe掺杂ZnCo-DMC催化CO2/PO共聚制备聚醚碳酸酯多元醇性能研究OA

Study on catalytic performance of Fe-doped ZnCo-DMC for copolymerization of CO2 and PO to polyether carbonate polyols

中文摘要英文摘要

聚醚碳酸酯多元醇是一种具有高附加值的化学品,可通过CO2与环氧丙烷(PO)共聚制备.ZnCo双金属氰化物(DMC)催化剂是合成聚醚碳酸酯多元醇的主要催化剂之一,但该催化剂目前存在反应速率快与产物中高CO2含量(质量分数,下同)不可兼得的问题.通过Fe掺杂改性ZnCo-DMC制备了Fe-ZnCo-DMC催化剂,结合XRD、SEM和FT-IR等系统探究了Fe-ZnCo-DMC在CO2/PO共聚制备聚醚碳酸酯多元醇反应中的构效关系,并进一步开展了公斤级放大试验及聚氨酯硬泡合成研究.结果表明,Fe掺杂未破坏催化剂主体结构,但显著降低了催化剂的结晶度,使表面呈小颗粒附着形貌,且热稳定性明显提升.在最佳反应条件(催化剂用量63 mg、反应时间6 h、温度105℃和压力4 MPa)下,小试中PO完全转化,副产物含量低于5%,CO2含量达20%左右.公斤级放大试验中,通过精准控制PO进料速度(3~5 mL/min),PO转化率接近100%,CO2含量高于15%,催化效率大于2.5 kg/g.以上述所得产品为原料,成功合成了高性能聚氨酯硬泡.

Polyether carbonate polyol is a high-value-added chemical that can be synthesized via the copolymerization of CO2 and propylene oxide(PO).ZnCo double metal cyanide(DMC)catalysts are among the primary catalysts used for the synthesis of polyether carbonate polyols.However,the catalysts currently face a trade-off between fast reaction rate and high CO2 content(mass fraction,same below)in the product.To address this limitation,the Fe-doped ZnCo-DMC catalyst(Fe-ZnCo-DMC)was developed.The structure-property relationship of Fe-ZnCo-DMC in copolymerization of CO2/PO was systematically studied by XRD,SEM,FT-IR,etc.Kilogram-scale amplification experiments and polyurethane rigid foam synthesis were further conducted.The results show that Fe doping does not disrupt the main catalyst structure but significantly reduces its crystallinity,resulting in a morphology with fine particles adhering to the surface,along with enhanced thermal stability.Under the optimized reaction conditions(catalyst dosage of 63 mg,reaction time of 6 h,temperature of 105℃and pressure of 4 MPa),the small-scale experiments achieve complete PO conversion,by-product content below 5%,and CO2 content of approximately 20%.In the kilogram-scale amplification experiments,precise control of the PO feeding rates(from 3 mL/min to 5 mL/min)enables nearly 100%PO conversion rate,CO2 content exceeding 15%,and catalytic efficiency greater than 2.5 kg/g.Meanwhile,high-performance polyurethane rigid foam was successfully synthesized using the obtained polyether carbonate polyol as a raw material.

孙晋冬;梁慧慧;赵雪;马灿亮;于杨

中石化南京化工研究院有限公司,江苏 南京 210048中石化南京化工研究院有限公司,江苏 南京 210048中石化南京化工研究院有限公司,江苏 南京 210048南京工业大学,江苏 南京 211816中石化南京化工研究院有限公司,江苏 南京 210048

化学化工

Fe掺杂ZnCo-DMCCO2构效关系聚醚碳酸酯多元醇聚氨酯

Fe dopingZnCo-DMCCO2structure-activity relationshippolyether carbonate polyolspolyurethane

《低碳化学与化工》 2026 (9)

61-69,9

中国石化重点实验室项目(KL223015).

10.12434/j.issn.2097-2547.20260077

评论