基于轴电压信号时频变换和深度残差收缩网络的同步发电机缺陷识别OA
Defect identification in synchronous generators based on time-frequency transformation of shaft voltage signals and deep residual shrinkage network
同步发电机运行过程中,轴系上的轴电压信号在某种程度上可以反映设备本身的运行工况.本文将轴电压信号作为特征信号,基于对信号的时频变换和深度残差收缩网络(DRSN),提出一种同步发电机缺陷识别方法.首先,开展三相同步发电机的缺陷模拟实验,利用数据采集卡采集正常及转子偏心、匝间短路、静电荷 3 种典型缺陷下的发电机轴电压信号;其次,分别采用 Mel 频谱变换和同步压缩变换 2 种时频变换构建数据集,并利用深度残差收缩网络构建特征提取器;最后,采用全连接层对图谱特征进行分类.研究结果表明,Mel-DRSN 模型对发电机缺陷的分类准确率达 99.05%,高于其他对比模型.所提出的方法为开展三相同步发电机缺陷检测提供了有效途径.
During the operation of a synchronous generator,the shaft voltage signal on the shaft system can,to some extent,reflect the equipment's operating condition.This paper proposes a defect identification method for synchronous generators using the shaft voltage signal as a feature signal,based on time-frequency transformation and a deep residual shrinkage network(DRSN).First,defect simulation experiments are conducted on a three-phase synchronous generator,where shaft voltage signals under normal conditions and three typical defects including rotor eccentricity,inter-turn short circuit,and electrostatic induction are acquired using an data acquisition card.Second,two time-frequency transforms,namely Mel spectrogram transform and synchrosqueezing transform,are respectively employed to construct datasets,and a deep residual shrinkage network is used to build a feature extractor.Finally,a full connected layer is adopted to classify the spectral features.The results show that the Mel-DRSN model achieves a classification accuracy of 99.05%for generator defects,outputing other compared models.The proposed method provides an effective aproach for defect identification in three-phase synchronous generators.
张新民;常野;朱建斌;陈鸿昌
海南核电有限公司,海南 昌江 572733海南核电有限公司,海南 昌江 572733海南核电有限公司,海南 昌江 572733海南核电有限公司,海南 昌江 572733
同步发电机轴电压时频变换深度残差收缩网络(DRSN)
synchronous generatorshaft voltagetime-frequency transformationdeep residual shrinkage network(DRSN)
《电气技术》 2026 (9)
21-27,33,8
海南核电汽轮发电机轴电流故障诊断及防治系统研制项目(A2207137)
评论