首页|期刊导航|制冷|制冷螺杆压缩机进油管接头振动分析与控制

制冷螺杆压缩机进油管接头振动分析与控制OA

Vibration Analysis and Control of Inlet Pipe Joint Refrigeration of Screw Compressor

中文摘要英文摘要

针对某型号制冷螺杆压缩机进油管接头振动超标的情况,经振动检测和模态分析排除共振因素.采用数值仿真方法分析进油油道流场特性,得出进油油道内液体脉动为振动超标的主要原因,并提出优化进油口油道结构的方案.采用减振方案后的流场特性显示,油路系统的最大流速下降了30.4%,压力不均度降低了46.1%,最大湍动能降低了82.4%.振动治理后,实验测试若干工况进油管接头处振动速度均方根,均低于GB/T 19410限定阈值5mm/s.振动超标现象得到有效控制,压缩机运行更加安静、稳定.

In response to the excessive vibration of the inlet pipe joint of the refrigeration screw compressor,resonance factors were excluded through vibration detection and modal analysis.Using numerical simulation methods to analyze the flow field characteristics of the inlet oil passage,it is found that liquid pulsation is the main cause of vibration exceeding the standard,and a plan to optimize the structure of the inlet oil passage is proposed.The flow field characteristics after adopting the vibration reduction scheme show that the maximum flow velocity of the oil system decreased by 30.2%,the pressure unevenness decreased by 46.1%,and the maximum turbulence energy decreased by 82.4%.After vibration control,the root mean square of vibration velocity at the inlet pipe joint under several operating conditions was tested and found to be below the threshold of 5 mm/s specified in GB/T 19410.The phenomenon of excessive vibration has been effectively controlled,and the operation of the compressor is quieter and more stable.

翁逸龙

福州大学机械工程及其自动化学院,福州,350108||福建雪人集团股份有限公司,长乐,350200

机械制造

螺杆压缩机供油优化振动数值仿真

Screw CompressorOil Supply OptimizationVibrationNumerical Simulation

《制冷》 2026 (4)

49-53,5

10.3969/J.ISSN.1005-9180.2026.04.0008

评论