首页|期刊导航|天然气勘探与开发|"一点法"气井产能评价校正系数β的确定

"一点法"气井产能评价校正系数β的确定OA

Determination of correction coefficient β of"one-point method"for gas well deliverability evaluation

中文摘要英文摘要

陈氏常规"一点法"天然气井产能评价方法以压力平方形式二项式产能方程为基础,取我国6个气田的16口气井68个测试点稳定经验数(α)平均值0.25.该方法对于小压差的高产气井计算误差较大.针对上述问题,以气井二项式产能方程为基础,基于常规"一点法"理论,推导出了"一点法"气井产能评价校正系数(β)和新的"一点法"校正产能计算公式;进而建立了气井产气量与产能试井拟合数据A、B、生产压差与地层压力之比(∆p/pR)和地层压力(pR)的关系式,根据中国25口典型气井现场数据,绘制了"一点法"气井产能评价综合校正图版,并对综合图版和常规"一点法"的计算误差进行了讨论.研究结果表明:①校正系数β与α和气井生产压差与地层压力比值(γ)相关;②当气井α<0.25时,β系数将小于0.5,当气井α>0.25时,β系数普遍小于1.2;③根据气井完井试油的地层压力、井底流压确定γ,先由产气量(qg)在综合校正图版的主坐标轴读取气井α系数,再由γ和α系数在次坐标轴读取校正系数β,即可确定气井绝对无阻流量(qAOF);④所建立的校正产能计算公式确定的气井产能评价结果优于常规"一点法",39口气井产能评价的平均相对误差由54.59%下降至7.81%.结论认为,当气井α不为0.25时,将现场测试数据与综合校正图版结合起来评价气井产能,可以提高气井产能评价的精度.

The conventional Chen's"one-point method"(C-OPM)for gas well deliverability evaluation is based on the binomial deliverability equation in pressure-squared form,adopting an average stabilized empirical coefficient(α)of 0.25 derived from 68 test points of 16 gas wells across 6 gas fields in China.However,this method exhibits significant calculation errors for high-yield gas wells with small drawdowns.To address the issue,a correction coefficient(β)and a new corrected deliverability calculation formula were derived based on the binomial deliverability equation and the C-OPM theory.Additionally,the relationships between gas production rate and the test-derived fitting parameters A and B,the ratio of drawdown to formation pressure(Δp/pR),and formation pressure(pR)were established.A comprehensive correction chart for OPM deliverability evaluation was developed using field data from 25 typical gas wells,and its calculation errors were compared with those of the C-OPM.The following results are obtained.(ⅰ)β is related to α and the ratio of gas well drawdown to formation pressure(γ).(ⅱ)When α<0.25,β is less than 0.5;and when α>0.25,β is generally below 1.2.(ⅲ)The procedure to determine the absolute open flow(qAOF)of wells involves calculating γ from formation pressure and bottom-hole flowing pressure obtained during well completion and oil testing,reading α from the primary axis of the correction chart using the gas production rate(qg),and then reading β from the secondary axis using γ and α.(ⅳ)The established corrected deliverability calculation formula yields more accurate evaluation results than the C-OPM,with the average relative error for 39 gas wells decreasing from 54.59%to 7.81%.It is concluded that,when α is not equal to 0.25,combining field test data with the correction chart is recommended to improve deliverability evaluation accuracy.

蔡珺君;张连进;张飞;毛正林;周芳芳;胡怡

中国石油西南油气田公司勘探开发研究院 四川 成都 610041中国石油西南油气田公司勘探开发研究院 四川 成都 610041中国石油西南油气田公司勘探开发研究院 四川 成都 610041中国石油西南油气田公司勘探开发研究院 四川 成都 610041中国石油西南油气田公司勘探开发研究院 四川 成都 610041中国石油西南油气田公司勘探开发研究院 四川 成都 610041

能源科技

校正系数"一点法"气井产能评价试井稳定经验数便捷性精度提高

Correction coefficient"One-point method"Gas well deliverability evaluationWell testStabilized empirical coefficientConvenienceAccuracy improvement

《天然气勘探与开发》 2026 (5)

102-110,9

国家科技重大专项项目"四川盆地深层超深层碳酸盐岩气藏勘探开发技术与集成示范"(编号:2025ZD1402500),中国石油西南油气田公司科技项目"薄层强非均质气藏跨尺度流动规律研究及气井稳产能力评价"(编号:25XNYTSC010).

10.12055/gaskk.issn.1673-3177.20250153

评论