电动汽车无线充电系统的悬浮电位抑制策略OA
Floating potential suppression strategy for wireless charging system of electric vehicles
为提升电动汽车无线充电系统的安全性,提出了电屏蔽层悬浮电位的抑制策略.通过分析屏蔽结构和耦合电路,推导了电屏蔽层悬浮电位的约束方程,并且使用场路耦合方法对悬浮电位进行数值计算;在高频逆变器的整流部分增加共模滤波器,逆变环节使用双极性脉冲信号调制方法,以减弱高频逆变电源输出的共模分量,同时耦合线圈采用双层布线的方式;搭建 85 kHz 电动汽车无线充电系统,使用前端差分浮地测量技术提取电屏蔽层的悬浮电位,验证本文方法的有效性.结果表明:采用本文方法后,传输 12.9 kW功率时电屏蔽层悬浮电位的峰值从1 041.10 V削弱到了65.25 V,并且在模拟人体触电实验中触电电流降低到0.91 mA,达到人体无感电流的标准.
In order to improve the safety of the wireless charging system for electric vehicles(EV-WCS),the floating po-tential(FP)suppression strategy for the electric shielding is proposed.By analyzing the shielding structure and coupling circuits,the constraint equations for the FP of the electrical shielding layer are derived,and it is nu-merically calculated using the field-circuit coupling method.A common-mode filter is added to the rectifier sec-tion of a high-frequency inverter,and a bipolar pulse signal modulation method is used in the inverter section to effectively attenuate the common-mode component output by a high-frequency inverter power supply.Mean-while,the coupling coils are wired in double layers.An 85 kHz EV-WCS is built,the FP of the electric shield is extracted using a front-end differential floating ground measurement technique to verify the effectiveness of the proposed method.The experimental results show that after adopting the proposed method,the peak floating po-tential of the electric shielding layer drops from 1 041.10 V to 65.25 V under a transmission power of 12.9 kW,and the electrocution current reduces to 0.91 mA in simulated human electrocution experiments,which reaches the standard of non-inductive current of human body.
祝丽花;赵帅;李元;田忠莹
天津工业大学 电气工程学院,天津 300387||天津理工大学 电气工程与自动化学院,天津 300384天津工业大学 电气工程学院,天津 300387天津工业大学 电气工程学院,天津 300387天津工业大学 电气工程学院,天津 300387
信息技术与安全科学
电动汽车变流器无线充电系统悬浮电位
electric vehiclesconverterwireless charging systemfloating potential
《天津工业大学学报》 2026 (4)
73-79,7
国家自然科学基金面上项目(52277016)国家自然科学基金优秀青年科学基金项目(52122701)
评论