汽车平行流冷凝器制冷剂充注量实验研究OA
Experimental study on refrigerant charge amount of automotive parallel flow condenser
针对进出口压板异侧布置的三流程冷凝器与过冷区上置的两流程冷凝器,开展制冷剂充注量实验,并与常规两流程冷凝器对比.结果表明:常规冷凝器过冷平台明显,充注量约 155 g;三流程冷凝器因进口高温经连接管传热导致过冷平台短(约 61 g),优化连接管位置后可提升至 159 g;过冷区上置冷凝器因气态制冷剂倒吸而无过冷平台,优化导管与连接管相对位置后平台正常出现(约 280 g).单纯增大储液罐内容积无效.优化结构可改善过冷平台,使充注量接近理论值.
Experiments on the refrigerant charge amount were conducted for a three-pass condenser with inlet and outlet headers arranged on opposite sides and a two-pass condenser with a subcooling zone placed above,and comparisons were made with a conventional two-pass condenser.The results showed that:for the conventional condenser,a distinct subcooling platform was observed,and the charge amount was about 155 g.For the three-pass condenser,due to heat transfer from the high-temperature inlet through the connecting pipe,a short subcooling platform(about 61 g)was caused;after the position of the connecting pipe was optimized,it was increased to 159 g.For the condenser with the subcooling zone placed above,no subcooling platform was present due to back-suction of gaseous refrigerant;after the relative position of the conduit and the connecting pipe was optimized,the platform appeared normally(about 280 g).Simply increasing the internal volume of the receiver was found to be ineffective.The subcooling platform could be improved by optimizing the structure,and the charge amount was made to approach the theoretical value.
吴笑宇;任永兵;侯海焱;张屹东
上海爱斯达克汽车空调系统有限公司,上海 201204上海爱斯达克汽车空调系统有限公司,上海 201204上海爱斯达克汽车空调系统有限公司,上海 201204上海爱斯达克汽车空调系统有限公司,上海 201204
交通工程
汽车平行流冷凝器过冷平台实验制冷剂充注量
automotive parallel flow condensersubcooling platform experimentrefrigerant charge amount
《农业装备与车辆工程》 2026 (8)
58-62,69,6
评论