首页|期刊导航|农业装备与车辆工程|半挂车空气悬架导向臂轻量化研究

半挂车空气悬架导向臂轻量化研究OA

Research on lightweighting of the guide arm of semi-trailer air suspension

中文摘要英文摘要

针对某 12 t 半挂车空气悬架导向臂在极限垂向冲击工况下安全系数不足的问题,优选高强度合金弹簧钢52GrMoV4替代原材,将初始安全系数提升至1.95;基于SIMP变密度法进行拓扑优化,识别出腹板中性层为材料冗余区域,据此设计腰形减重孔并完成模型重构.强度校核结果表明:优化后导向臂在极限工况下最大应力为1 139.4 MPa,低于材料屈服极限 1 175 MPa,安全系数达 1.40,满足设计要求.与原始模型相比,单件质量由 32.9 kg降至 31.4 kg,减重比例 4.56%,静刚度损失仅 9.8%,处于可控范围.可为复合式空气悬架导向臂的轻量化设计提供参考.

To address the problem of an insufficient safety factor of a certain 12 t semi-trailer air suspension guide arm under extreme vertical impact conditions,a high-strength alloy spring steel,52GrMoV4,was selected to replace the original material,and the initial safety factor was raised to 1.95.Based on the SIMP variable density method,topology optimization was performed,and the neutral layer of the web was identified as a material redundant region.Accordingly,waist-shaped lightweight holes were designed,and the model was reconstructed.The strength check results showed that the maximum stress of the optimized guide arm under extreme conditions was measured to be 1 139.4 MPa,which was lower than the material yield limit of 1 175 MPa,and the safety factor was calculated to be 1.40;thus,the design requirements were satisfied.Compared with the original model,the mass per part was reduced from 32.9 kg to 31.4 kg,achieving a weight reduction ratio of 4.56%,and the static stiffness loss was only 9.8%,which was considered to be within a controllable range.Therefore,a reference for the lightweight design of composite air suspension guide arms was provided.

张淼;赵长利;陈秀生;李大成;王九川

山东交通学院 汽车工程学院,山东 济南 250357山东交通学院 汽车工程学院,山东 济南 250357济南大学 机械工程学院,山东 济南 250022山东正阳机械股份有限公司,山东 济宁 272614山东正阳机械股份有限公司,山东 济宁 272614

交通工程

空气悬架导向臂有限元分析轻量化拓扑优化变密度法

air suspension guide armfinite element analysislightweight designtopology optimizationvariable density method

《农业装备与车辆工程》 2026 (8)

26-30,43,6

山东省重点研发计划"12t空气悬架的轻量化设计及产业化"(2025TSGCCZZB0681)

10.3969/j.issn.1673-3142.2026.08.004

评论