首页|期刊导航|河南城建学院学报|装配式预制楼板-墙体L形企口连接节点受弯性能试验研究

装配式预制楼板-墙体L形企口连接节点受弯性能试验研究OA

Experimental study on flexural performance of prefabricated floor-to-wall L-shaped tongue and groove joints

中文摘要英文摘要

为研究装配式预制楼板-墙体连接节点构造对其受力性能的影响,以板-墙节点处是否预留L形企口和配置弯起钢筋为影响因素,设计并制作三组代表性试件.对楼板试件悬臂端施加单调竖向荷载进行静力试验,结果表明:试件破坏形式均为板-墙节点附近的受弯破坏,裂缝均分布于节点区域;但分布形态因构造不同而有所差异;楼板预留企口、未配置弯起钢筋时,节点受弯承载力比现浇节点降低约10.26%;预留企口配置弯起钢筋时,节点受弯承载力较现浇试件提高37.5%,较仅预留企口、未配置弯起钢筋的试件提升更为显著.研究表明,楼板预留L形企口且配置附加弯起钢筋的后浇连接节点强度较高,可按等同现浇进行设计.研究结果可推广应用于装配式建筑板-墙节点连接.

To study the influence of the structural difference at the prefabricated floor-to-wall joints on the flexural performance,representative specimens in three groups were fabricated considering floor-to-wall joint details of L-shaped tongue and groove and bent steel bars.The static test was carried out by applying monotonic vertical load on the cantilever end of the specimen floor.The results show that the failure modes of the specimens are all flexural failure near the plate-wall joint,and the crack distribution forms are basically the same.For specimens with an L-shaped tongue and groove but without bent steel bars,the flexural capacity of the joint is about 10.26%lower than that of the cast-in-place joint.Compared with the cast-in-place specimen,the flexural capacity of the joint is increased by 37.5%,and the improvement is more significant than that of the specimen with only reserved notch and without additional reinforcement.The research shows that the post-cast connection joint with L-shaped tongue and groove reserved in the floor slab and additional bent steel bars has high strength,which can be designed as equivalent cast-in-place.This result is suitable for practical application in prefabricated building systems.

张锋剑;张益源;张远;王启源;刘志钦;徐振宇;楚留声;苏群山;徐笑东;王福梅

河南城建学院 智能建造与交通工程学院,河南 平顶山 467036河南城建学院 智能建造与交通工程学院,河南 平顶山 467036西安建筑科技大学 土木工程学院,陕西 西安 710055河南城建学院 智能建造与交通工程学院,河南 平顶山 467036河南城建学院 智能建造与交通工程学院,河南 平顶山 467036河南省建筑科学研究院有限公司,河南 郑州 450053郑州大学 土木工程学院,河南 郑州 450001河南省第二建设集团有限公司,河南 郑州 451464河南省第二建设集团有限公司,河南 郑州 451464河南城建学院 智能建造与交通工程学院,河南 平顶山 467036

建筑与水利

装配式预制楼板-墙体连接L形企口受弯承载力后浇带

prefabricated floor-to-wall connectionL-shaped tongue and grooveflexural capacitypost-cast strip

《河南城建学院学报》 2026 (4)

20-29,10

河南省科技研发计划联合基金项目(252103810034)河南省科技攻关项目(252102240135)河南省住房和城乡建设科学技术计划项目(HNJS-2022-K28)

10.14140/j.cnki.hncjxb.2026.04.003

评论