首页|期刊导航|工业技术与职业教育|基于动力分析的钢混组合梁跨既有桥施工工艺优化与安全控制

基于动力分析的钢混组合梁跨既有桥施工工艺优化与安全控制OA

Optimization of Construction Process and Safety Control of Steel-Concrete Composite Beams over Existing Bridges Based on Dynamic Analysis

中文摘要英文摘要

钢混组合梁在城市立交跨线工程中具有自重较轻、施工效率高、对交通影响相对较小等优势,但在跨既有桥施工过程中,新建结构、临时支撑与既有桥梁共同形成复杂受力体系,施工荷载与通行荷载叠加后,易对既有桥梁动力安全产生不利影响.依托河北省某互通立交77 m跨钢混组合梁工程,采用"临时支撑与节段吊装"施工模式,建立"临时支撑—既有桥"有限元模型,并采用三角荷载模拟车辆移动荷载,对施工阶段既有桥的动力响应进行分析.结果表明,临时支撑的介入显著改变了既有桥的动力刚度分布,不同跨位的位移和加速度响应差异明显;在限速 5 km/h、代表车辆按 5 t、双车道同步通行的条件下,既有桥最大竖向位移为-0.54 mm,最大竖向加速度为 0.11 m/s²,整体响应处于可控范围.研究表明,该施工工艺与交通组织方式能够满足跨线施工安全要求,可为同类钢混组合梁跨既有桥梁工程提供参考.

Steel-concrete composite beams offer advantages such as relatively light self-weight,high construction efficiency,and minimal impact on traffic in urban interchange overpass projects.However,during construction over existing bridges,the newly built structure,temporary supports,and the existing bridge form a complex force system.The superposition of construction loads and traffic loads can adversely affect the dynamic safety of the existing bridge.Based on a 77 m-span steel-concrete composite beam project at an interchange in Hebei Province,this study employs a"temporary support and segmental lifting"construction method.A finite element model of the"temporary support–existing bridge"system is established,and a triangular load is used to simulate moving vehicle loads,allowing analysis of the dynamic response of the existing bridge during construction.Results indicate that the introduction of temporary supports significantly alters the dynamic stiffness distribution of the existing bridge,with notable differences in displacement and acceleration responses across different spans.Under a speed limit of 5 km/h and representative vehicles of 5 t crossing two lanes simultaneously,the maximum vertical displacement and acceleration of the existing bridge are-0.54 mm and 0.11 m/s²,respectively,with overall responses remaining within controllable limits.The study demonstrates that this construction technique and traffic organization method can meet safety requirements for overpass construction and provides a reference for similar steel-concrete composite beam projects over existing bridges.

张洪强;褚何伟;曹文龙

石家庄市政工程有限公司,河北 石家庄 050000北京兴铁建筑工程有限公司,北京 100045河北省季冻区公路服役安全与预警技术创新中心,河北 石家庄 050091||河北交通职业技术学院,河北 石家庄 050091

交通工程

钢混组合梁跨线施工施工工艺创新动力分析临时支撑

steel-concrete composite beamoverpass constructioninnovative construction techniquedynamic analysistemporary support

《工业技术与职业教育》 2026 (4)

28-32,5

河北省建设科技研究计划项目"装配式钢-混组合梁桥施工连接技术及其疲劳性能研究"(项目编号:2025-2127),主持人曹文龙.

评论