首页|期刊导航|电化学(中英文)|原位自组装SmMn2O5-NiMn2O4双相复合阴极的制备及性能研究

原位自组装SmMn2O5-NiMn2O4双相复合阴极的制备及性能研究OA

Preparation and Performance Study of In-Situ Self-Assembled Biphasic SmMn2O5-NiMn2O4 Composite Cathode

中文摘要英文摘要

莫来石结构氧化物具有优异的氧还原反应 活性,得益于其独特的晶体结构而表现出较低的热膨胀系数(TEC),且由于不含碱土元素,可避免使用阻挡层并简化制备工艺.因此,它们作为新型固体氧化物燃料电池 阴极材料具有广阔的应用前景.本工作通过固-液复合路线一步法合成了莫来石-尖晶石结构的SmMn2O5-NiMn2O4(SMO-NMO)复合阴极,其原位自组装特性使其在无需阻挡层的情况下即可与电解质实现良好的界面匹配.表征结果表明,当 SMO:NMO=5:5(SN55)时,复合阴极通过两相之间的协同作用,克服了单相材料的性能瓶颈-即纯 SMO 导电性低(800 ℃ 时仅为 0.035 S·cm-1)以及纯 NMO氧还原反应 活性不足的问题.在 800 ℃ 下,全电池的峰值功率密度达到 1069.82 mW·cm-2,分别为纯SMO(329.92 mW·cm-2)和纯 NMO(890.20 mW·cm-2)的 3.24倍和 1.20倍.以SN55为阴极的全电池在 750 ℃、540 mA·cm-2 条件下恒流放电 150 h 后,电压衰减约为 1.6%,平均衰减率为 5.62%/kh,且阴极-电解质界面未出现任何缺陷与元素偏析.本研究为设计无阻挡层固体氧化物燃料电池阴极材料提供了一条新的思路.

Mullite-structured oxides exhibit excellent oxygen reduction reaction activity,possess a low thermal expansion coef-ficient due to their unique crystal structure,and can eliminate the need for a barrier layer and simplify the preparation process as they contain no alkaline earth elements.Thus,they hold great promise as novel cathode materials for solid ox-ide fuel cells.In this work,a mullite-spinel-structured SmMn2O5-NiMn2O4(SMO-NMO)composite cathode was one-step synthesized via a solid-liquid composite route,and its in-situ self-assembly enabled good compatibility with the electrolyte without any barrier layer.Characterization results showed that the SMO:NMO=5:5(SN55)composite cathode overcame the bottlenecks of single-phase materials-namely,the low conductivity of pure SMO(only 0.035 S·cm-1 at 800 ℃)and the insufficient oxygen reduction reaction activity of pure NMO-through a synergistic effect between the two phases.At 800 ℃,the single cell delivered a peak power density of 1069.82 mW·cm-2,which was 3.24-fold and 1.20-fold higher than that of pure SMO(329.92 mW·cm-2)and NMO(890.20 mW·cm-2),respectively.Under galvanostatic operation at 750 ℃(cur-rent density corresponding to 540 mA·cm-2),the SN55-based cell runs for~150 h with only 1.6%voltage loss,corresponding to a degradation rate of 5.62%/kh,and no defects appeared at the cathode-electrolyte interface.This study provided a new route for designing barrier-layer-free cathodes for solid oxide fuel cells.

夏能楚;周宇;王琴;张家友;余春;张旸;官万兵;王建新

宁波大学材料科学与化学工程学院,浙江 宁波,315211||中国科学院宁波材料技术与工程研究所,全省先进燃料电池与电解池技术重点实验室,浙江 宁波,315201中国科学院宁波材料技术与工程研究所,全省先进燃料电池与电解池技术重点实验室,浙江 宁波,315201宁波大学材料科学与化学工程学院,浙江 宁波,315211中国科学院宁波材料技术与工程研究所,全省先进燃料电池与电解池技术重点实验室,浙江 宁波,315201中国科学院宁波材料技术与工程研究所,全省先进燃料电池与电解池技术重点实验室,浙江 宁波,315201中国科学院宁波材料技术与工程研究所,全省先进燃料电池与电解池技术重点实验室,浙江 宁波,315201中国科学院宁波材料技术与工程研究所,全省先进燃料电池与电解池技术重点实验室,浙江 宁波,315201中国科学院宁波材料技术与工程研究所,全省先进燃料电池与电解池技术重点实验室,浙江 宁波,315201

固体氧化物燃料电池阴极莫来石无阻挡层原位复合材料

Solid oxide fuel cellCathodeMulliteBarrier-freeIn-situ composite

《电化学(中英文)》 2026 (7)

14-26,13

This work was supported by the National Natural Science Foundation of China(Grant No.U24A2062)and Ningbo Key R&D Program Project(grant num-ber 2023Z145).

10.61558/2993-074X.3615

评论