不同直径钨纤维增强金属玻璃复合材料长杆弹自锐行为及侵彻/穿甲性能OA
Self-sharpening behavior and penetration/perforation property of tungsten fiber/metallic glass composite long rods with different fiber diameters
为对比不同直径钨纤维增强金属玻璃(tungsten fiber/metallic glass,WF/MG)复合材料长杆弹的侵彻/穿甲自锐行为以及相应弹道性能的异同,综合侵彻/穿甲试验结果和细观有限元模拟,系统开展不同长杆弹在侵彻/穿甲钢靶过程中的弹靶变形和破坏特性研究,并分析长杆弹在不同撞击速度下变形和破坏模式的转变.结果表明:由于不同直径钨纤维在抗弯曲、抗剪切等方面性能存在差异,相应复合材料弹体在侵彻过程中表现出不同的破坏特征,从而影响其侵彻/穿甲性能.撞击速度对弹体的变形和破坏模式及其侵彻/穿甲性能也具有显著影响:速度较低时,在钨纤维直径较小的情形下,弹体头部纤维在侵彻过程中表现出屈曲失稳现象且逐渐分散,使得弹头发生一定程度的钝粗,并导致侵彻阻力增大和侵彻性能下降;随撞击速度的提高,在纤维直径较小的情形下,弹体外侧纤维发生回流;在钨纤维直径较大时则主要发生剪切破坏,使得弹头进一步锐化并导致侵彻/穿甲性能提升;当撞击速度和钨纤维直径达到某一上限阈值时,弹体头部边缘层厚度急剧减小,自锐性能有所弱化,侵彻/穿甲能力再次降低.
In order to compare the similarities and differences among the self-sharpening behavior as well as the corresponding ballistic performance of tungsten fiber/metallic glass matrix(WF/MG)composite long rod projectile with different fiber diameters,the deformation and failure characteristics of various WF/MG composite long rod projectile were investigated systematically integrated with related penetration test results and mesoscopic finite element(FE)simulation analysis.The two-dimensional(2D)and three-dimensional(3D)meso-scale FE geometric models of WF/MG composite long rod projectile were established according to the actual distribution characteristics of metallic glass matrix and tungsten fibers.A coupled'thermo-mechanical-free volume'constitutive model was applied to characterize the high shear sensitivity as well as high strength of metallic glass matrix.Moreover,the transformation of deformation and failure modes of projectiles under different impact velocities was analyzed in detail.Related analysis demonstrated that due to the differences in the mechanical properties among the tungsten fibers with different diameters,i.e.,bending resistance and shear resistance,etc.,the corresponding composite long rod projectile exhibit different failure characteristics during the penetration process,which further affects their penetration/perforation performance.The impact velocity also plays an important role on the deformation and failure modes of composite long rod projectile and the corresponding penetration/perforation performance.When the impact velocity is relatively low,the fibers in the nose of composite rod projectile exhibits unstable buckling phenomenon and gradually disperse during the penetration process,which makes the projectile nose blunt at a certain extent.This induces the increase in the penetration resistance and decrease in the penetration performance.As the impact velocity increases,small-diameter fibers reflux along the nose periphery while large-diameter fibers fail in shear.The large-diameter fiber further strengthens the self-sharpening behavior as well as the penetration performance of projectile.When the impact velocity and fiber diameter reach a certain upper threshold values,the thickness of'edge layer'in the rod nose is sharply reduced,and thus the self-sharpening performance is weakened,and the penetration capability of projectile is decayed again.Related research is beneficial to predicting the penetration/perforation performance of WF/MG composite long rod projectiles with different fiber diameters under different impact velocities,and optimizing the structural design of projectile as well as the impact velocity,etc.
任杰;章浪;李继承;邓勇军;陈小伟;杜成鑫
西南科技大学土木工程与建筑学院,四川 绵阳 621010||工程材料与结构冲击振动四川省重点实验室,四川 绵阳 621010西南科技大学土木工程与建筑学院,四川 绵阳 621010||工程材料与结构冲击振动四川省重点实验室,四川 绵阳 621010工程材料与结构冲击振动四川省重点实验室,四川 绵阳 621010||中国工程物理研究院总体工程研究所,四川 绵阳 621999西南科技大学土木工程与建筑学院,四川 绵阳 621010||工程材料与结构冲击振动四川省重点实验室,四川 绵阳 621010工程材料与结构冲击振动四川省重点实验室,四川 绵阳 621010||北京理工大学前沿交叉研究院,北京 100081南京理工大学机械工程学院,南京 210094
数理科学
钨纤维增强金属玻璃复合材料长杆弹侵彻/穿甲自锐纤维直径破坏模式有限元模拟
tungsten fiber/metallic glass composite long rodpenetration/perforationself-sharpeningfiber diameterfailure modefinite element simulation
《爆炸与冲击》 2026 (9)
101-119,19
国家国防科技工业局科研专项(KJSP2023020304)四川省自然科学基金(2023NSFSC1913)
评论