基于电感辨识的IPMSM高频方波注入解调补偿方法OA
A Demodulation Compensation Method for High-Frequency Square-Wave Injection in IPMSM Based on Inductance Identification
[目的]针对内置式永磁同步电机零低速高频方波注入位置观测中,d、q轴电感随运行工况变化导致解调系数失配,进而降低位置观测精度的问题,提出一种基于在线电感辨识的解调系数自适应补偿方法.[方法]首先建立高频方波注入解调模型,通过差分法提取高频电流,推导电感变化对解调系数及位置观测误差的传递机理;在此基础上,引入模糊逻辑的级联模型参考自适应系统(FLC-MRAS)在线辨识Ld、Lq,利用辨识结果实时重构解调系数,对两相解调信号进行补偿,再将相位误差信号输入锁相环,实现转子位置与速度的闭环估计,减弱参数变化对系统的影响.[结果]基于Matlab/Simulink平台进行了仿真分析.结果表明,在转速阶跃工况下FLC-MRAS的Ld、Lq辨识最大误差较传统MRAS分别减小了 94.1%、97.1%.与传统高频方波注入相比,补偿后速度误差负峰值和正向反冲峰值分别减小43.9%和42.4%,位置误差峰值减小30.6%.在负载阶跃工况下,Ld、Lq辨识最大误差分别减小85.7%、95.7%,速度跌落幅值和误差峰值分别减小70.8%和64.8%,角度误差幅值减小60.0%.[结论]本文所提方法基于FLC-MRAS在线辨识电感实时修正高频解调模型,减弱电感变化引起的系数失配,提高转速和转子位置观测精度,并增强系统在不同工况下的鲁棒性.
[Objective]To address the issue of demodulation coefficient mismatch caused by variations in d-axis and q-axis inductances due to changing operating conditions,which degrades position observation accuracy in zero-and low-speed interior permanent magnet synchronous motor drives using high-frequency square-wave signal injection,an adaptive demodulation coefficient compensation method based on online inductance identification is proposed.[Methods]Firstly,a high-frequency square-wave injection demodulation model was established.The difference method was used to extract the high-frequency current,and the transfer mechanism of how inductance variation affects the demodulation coefficient and position observation error was derived.On this basis,a fuzzy logic cascade model reference adaptive system(FLC-MRAS)was employed to identify Ld and Lq online.The identification results were then used to reconstruct the demodulation coefficients in real time,compensating the two-phase demodulation signals.Finally,the phase error signal was fed into a phase-locked loop to achieve closed-loop estimation of rotor position and speed,thereby mitigating the impact of parameter variations on the system.[Results]Simulations were conducted on the Matlab/Simulink platform.The results indicated that under the speed step condition,the maximum identification errors of Ld and Lq using FLC-MRAS were reduced by 94.1%and 97.1%,respectively,compared to the traditional MRAS.Compared with conventional high-frequency square-wave injection,the negative peak and positive overshoot of the speed error were decreased by 43.9%and 42.4%after compensation,and the peak position error was reduced by 30.6%.Under the load step condition,the maximum identification errors of Ld and Lqwere lowered by 85.7%and 95.7%,respectively;the speed drop amplitude and error peak were decreased by 70.8%and 64.8%;and the amplitude of the angular error was reduced by 60.0%.[Conclusion]The proposed method is based on FLC-MRAS online inductance identification to correct the high-frequency demodulation model in real time,which mitigates coefficient mismatch caused by inductance variations,improves the observation accuracy of speed and rotor position,and enhances system robustness under different operating conditions.
张峻博;许鸣珠;邢茜;郭希文;陈旭升
石家庄铁道大学机械工程学院,河北石家庄 050043石家庄铁道大学机械工程学院,河北石家庄 050043河北兴隆重设备有限公司,河北唐山 064000河北兴隆重设备有限公司,河北唐山 064000中国铁路沈阳局集团有限公司沈阳工务段,辽宁沈阳 110001
信息技术与安全科学
内置式永磁同步电机高频方波注入解调系数模型参考自适应系统
interior permanent magnet synchronous motorhigh-frequency square-wave injectiondemodulation coefficientmodel reference adaptive system
《电机与控制应用》 2026 (8)
765-778,14
国家自然科学基金(U22A20246)National Natural Science Foundation of China(U22A20246)
评论