三元复合驱污水处理工艺运行界限数值模拟研究OA
Numerical Simulation on Operation Boundary of Produced Water Treatment Process for ASP Flooding
三元复合驱作为提高油田采收率的有效手段,因其采出污水中碱、表面活性剂及聚合物浓度升高,给污水处理系统的绿色高效分离带来了挑战.目前,由于处理工艺运行界限不明确,在来水水质波动时,出水水质不达标的现象频发.为此,文章构建了三元复合驱污水处理工艺的物理模型,其中沉降过程采用欧拉模型与RNG k-ε湍流模型进行模拟;过滤过程则采用多孔介质模型,并耦合DPM离散相模型追踪颗粒迁移.通过分析工艺运行参数对处理效果的影响,发现处理量增加和污水含聚浓度的升高均会抑制工艺性能.基于模拟结果,采用多项式插值法确定了各工艺节点同时满足出水含油量与悬浮物含量均低于20 mg/L时的水质条件,由此建立了工艺运行界限,为现场优化运行提供了理论依据.
As an effective method to enhanced Oil Recovery(EOR)in oilfiedlds,Alkaline/Surfactant/Polymer(ASP)flooding brings changes to the green and efficient separation of the produced water due to the increased concentrations of alkalis,surfactants,and polymers.At present,the unclear operation boundary of the treatment process frequently caused substandard effluent water quality when the influent water quality fluctuated.Therefore,a physical model was established to simulate the treatment process of ASP flooding produced water.The Euler model combined with the RNG k-ε turbulence model was adopted to simulated the sedimentation process,while the porous medium model coupled with the Discrete Phase Model(DPM)was used for the filtration process to track particle migration.By analyzing the influence of operational parameters on treatment performance,it was found that tje increase of treatment capacity and the rise of polymer concentration in produced water could inhibit the treatment efficiency.Based on the simulation results,polynomial interpolation method was employed to determine the water quality conditions at each process node that simultaneously satisfy the requirements of oil and suspended solids concentration in effluent below 20 mg/L.Consequently,the operation boundary of the treatment process was established,which provided a theoretical basis for the on-site optimization of process operations.
马晓薇
中国石油大庆油田有限责任公司第一采油厂
资源环境
三元复合驱污水沉降过滤运行界限数值模拟
ASP flooding produced watersedimentationfiltrationoperation boundarynumerical simulation
《油气田环境保护》 2026 (4)
32-45,14
评论