CO2和Cl-耦合作用下P110钢气液界面腐蚀产物膜及膜下腐蚀行为OA
Corrosion Product Films and Under-film Corrosion Behavior at Gas-liquid Interface of P110 Steel under CO2 and Cl-Coupling Effects
为研究常压湿CO2和Cl-环境下P110钢的气液界面腐蚀行为,采用半浸泡腐蚀试验模拟气相区、气液界面区和液相区共存的局部服役环境,并结合动电位极化曲线、电化学阻抗谱、SEM、EDS及截面形貌分析,考察Ar和CO2气氛下NaCl浓度对P110钢腐蚀产物膜及膜下腐蚀行为的影响.结果表明,在饱和CO2的NaCl溶液中,当NaCl浓度由50 g/L升高至150 g/L时,P110钢腐蚀电流密度由9.252×10-5 A/cm2增大至1.407×10-4 A/cm2,腐蚀速率由1.076 mm/a升高至1.636 mm/a,表明Cl-浓度升高促进了P110钢的电化学腐蚀过程.半浸泡腐蚀10 d后,试样表面腐蚀形貌沿高度方向呈现出明显区域分化,其中气液界面区腐蚀最为严重.Ar气氛下生成腐蚀产物较少,主要表现为零散颗粒状;CO2气氛下表面生成FeCO3.随着NaCl浓度升高,CO2气氛下腐蚀产物颗粒细化并呈不均匀堆积,膜与基体结合性降低,截面可见疏松腐蚀产物和膜下腐蚀缺陷.P110钢在CO2和NaCl半浸泡体系中的气液界面腐蚀主要受CO2酸化、Cl-促进电荷转移及腐蚀产物膜局部破坏共同控制.
To investigate gas-liquid interface corrosion behavior of P110 steel in humid CO2 and Cl-environment,a semi-immersion corrosion test was conducted to simulate a localized service environment in which gas phase,gas-liquid interface,and liquid phase coexist.Combined with potentiodynamic polarization curves,electrochemical impedance spectroscopy,SEM,EDS,and cross-sectional morphology analysis,effects of NaCl concentration under Ar and CO2 atmospheres on corrosion product film and under-film corrosion behavior of P110 steel were examined.Results show that in NaCl solution saturated with CO2,as the NaCl concentration increased from 50 g/L to 150 g/L,the corrosion current density of P110 steel increased from 9.252×10-5 A/cm2 to 1.407×10-4 A/cm2,and corrosion rate increased from 1.076 mm/a to 1.636 mm/a.This indicates that an increase in Cl-concentration promotes the electrochemical corrosion process of P110 steel.After 10 days semi-immersion corrosion,the surface corrosion morphology of the sample exhibited distinct differences along the height direction,with the most severe corrosion occurring in the gas-liquid interface region.Under the Ar atmosphere,only a small amount of corrosion products formed,mainly appearing as scattered granular deposits.In contrast,under the CO2 atmosphere,a large number of crystalline corrosion products FeCO3 were formed on the steel surface.With increasing NaCl concentration,the corrosion product particles formed under the CO2 atmosphere became finer and accumulated unevenly.The continuity of the product film and the adhesion between the film and the substrate decreased.Cross-sectional observations revealed loose corrosion products and under-film corrosion defects.The gas-liquid interface corrosion of P110 steel in the NaCl solution saturated with CO2 semi-immersion system is mainly controlled by the combined effects of CO2 induced acidification,charge transfer accelerated by Cl-and localized degradation of the corrosion product film.
张慧慧;王晋泽;杨桐;席海璐
西安科技大学 材料科学与工程学院,西安 710054西安科技大学 材料科学与工程学院,西安 710054西安科技大学 材料科学与工程学院,西安 710054西安科技大学 材料科学与工程学院,西安 710054
矿业与冶金
P110钢气液界面腐蚀CO2腐蚀NaCl腐蚀产物膜电化学阻抗
P110 steelgas-liquid interface corrosionCO2 corrosionNaClcorrosion product filmelectrochemical impedance spectroscopy
《焊管》 2026 (8)
52-63,12
陕西省自然科学基础研究计划资助项目面上项目"纳米材料改性对橡胶密封件在超临界CO2环境中抗溶胀性和机械性能的提升机制"(项目编号2025JC-YBMS-611).
评论