基于双转子连续混炼挤出机的热塑性淀粉制备及工艺参数的影响OA
Preparation of thermoplastic starch via twin-rotor continuous mixing extrusion and influence of process parameters
以玉米淀粉为原料,甘油作为增塑剂,采用双转子连续混炼挤出机通过熔融挤出法制备热塑性淀粉,对不同转速及加料量下热塑性淀粉的微观结构、结晶性能、力学性能以及疏水性能进行了分析,探究了工艺参数对热塑性淀粉结构和性能的影响规律.结果表明,适当提高转速和加料量有利于淀粉的塑化,热塑性淀粉的结晶度降低,韧性和疏水性有所提高,但是转速或加料量过大会对热塑性淀粉的性能产生负面影响;当转速为200 rad/min,加料量为3 kg/h时,热塑性淀粉具有良好的综合性能,此时材料的拉伸强度为0.74 MPa,断裂伸长率为195%,接触角为88.4(°).
Using corn starch as the raw material and glycerol as the plasticizer,thermoplastic starch(TPS)was success-fully fabricated via melt extrusion with a twin-rotor continuous mixing extruder.The effects of key process parameters,including screw speed and feed rate,on the microstructure,crystalline structure,mechanical performance,and hydropho-bicity of TPS were systematically investigated to clarify the correlation between processing conditions and material struc-ture and properties.The experimental results show that moderate increases in screw speed and feed rate facilitate the plasticization of starch,which reduces the crystallinity of TPS and effectively improves its toughness and hydrophobicity.Nevertheless,excessively high screw speed or feed rate exerts adverse impacts on the comprehensive performance of TPS.The optimal overall performance of the prepared TPS is obtained at a screw speed of 200 rad/min and a feed rate of 3 kg/h.Under this optimal condition,the TPS sample achieves tensile strength of 0.74 MPa,elongation at break of 195%,and a water contact angle of 88.4 °.
代久双;冉真真;万舟;罗贵莹;李果;谢林生
华东理工大学,绿色高效过程装备与节能教育部工程研究中心,上海 200237||泸州北方化学工业有限公司,四川 泸州 646003泸州北方化学工业有限公司,四川 泸州 646003华东理工大学,绿色高效过程装备与节能教育部工程研究中心,上海 200237泸州北方化学工业有限公司,四川 泸州 646003华东理工大学,绿色高效过程装备与节能教育部工程研究中心,上海 200237华东理工大学,绿色高效过程装备与节能教育部工程研究中心,上海 200237
化学化工
热塑性淀粉双转子连续混炼挤出机转速加料量
thermoplastic starchtwo-rotor continuous mixing extruderrotor speedfeeding rate
《中国塑料》 2026 (8)
71-76,6
评论