首页|期刊导航|现代制造工程|机加工与阳极化顺序对7050-T7451铝合金细节疲劳额定截止值的影响研究

机加工与阳极化顺序对7050-T7451铝合金细节疲劳额定截止值的影响研究OA

Influence of machining and anodising sequence on detail fatigue rating cutoff of 7050-T7451 aluminium alloy

中文摘要英文摘要

7050-T7451铝合金作为航空航天关键结构材料,其疲劳性能直接影响构件可靠性,而细节疲劳额定截止值(DFRcutoff)是评估材料疲劳性能的重要指标,对疲劳寿命分析有重要意义.通过DFRcutoff试验片级试验,对比研究了机加工和阳极化先后顺序对该材料DFRcutoff的影响,试验设计包含先机加工后阳极化和先阳极化后机加工两种方案.结果表明,先阳极化后机加工工艺下的DFRcutoff值显著高于先机加工后阳极化工艺,相对提升幅度为12%,结合试验结果,提出基于服役环境的工艺顺序适用场景确定原则,可为该材料构件的疲劳设计及工艺优化提供量化依据.

As a critical structural material in the aerospace industry,the fatigue performance of 7050-T7451 aluminum alloy di-rectly affects the reliability of components.Detail Fatigue Rating cutoff(DFRcutoff)is a key indicator for evaluating the fatigue performance of materials and holds great significance for fatigue life analysis.The effects of the sequence of machining and anodi-zing on the DFRcutoff of this material are comparatively investigated via DFRcutoff specimen-level tests.Two test processes are de-signed,namely machining followed by anodizing and anodizing followed by machining.The results show that the DFRcutoff value under the anodizing followed by maching process is significantly higher than that of the maching followed by anodizing process,with a relative increase of 12%.Based on the test results,a principle for determining the applicable scenarios of the process se-quence according to the service environment is proposed,which can provide a quantitative basis for the fatigue design and process optimization of components made from this material.

姜昊;杨荣;邹鹏;刘玄

中航通飞华南飞机工业有限公司,珠海 519000中航通飞华南飞机工业有限公司,珠海 519000中国飞机强度研究所强度与结构完整性全国重点实验室,西安 710065中航通飞华南飞机工业有限公司,珠海 519000

航空航天

阳极化7050-T7451铝合金细节疲劳额定截止值疲劳机加工顺序

anodising7050-T7451 aluminium alloydetail fatigue rating cutofffatiguemachiningsequence

《现代制造工程》 2026 (8)

90-95,6

工信部民机预研课题项目(HN-2024-KJ-06004)

10.16731/j.cnki.1671-3133.2026.08.012

评论