重载工业机器人机电耦合振动抑制研究OA
Research on electromechanical coupling vibration suppression of heavy-duty industrial robots
针对重载工业机器人关节在启停工况下产生的末端残余振动问题,提出一种基于机电耦合建模的输入整形抑制方法.首先,构建了包含电机、减速机及负载的关节系统机电耦合动力学模型,揭示了系统振动产生的内在机理.在此基础上,依据仿真分析获得的系统振动参数,分别设计了零振动(ZV)和极不灵敏(EI)两种输入整形器.随后,利用Simulink仿真平台对两种输入整形器的振动抑制性能进行了系统对比分析.最后,通过搭建重载工业机器人试验平台开展实际测试.试验结果表明,ZV和EI输入整形器分别实现了 31.25%与41.02%的峰值抑制率,验证了基于机电耦合分析的输入整形抑制方法在抑制重载工业机器人末端残余振动方面的有效性.
Aiming at the problem of residual vibration at the end of the joints of heavy-duty industrial robots under start-stop con-ditions,an input shaping suppression method based on electromechanical coupling modeling was proposed.Firstly,the electrome-chanical coupling dynamics model of the joint system including motor,reducer and load was constructed,and the internal mecha-nism of system vibration was revealed.On this basis,according to the system vibration parameters obtained from simulation analy-sis,two input shapers with Zero Vibration(ZV)and Extremely Insensitive(EI)were designed respectively.Then,the vibration suppression performance of the two input shapers was systematically compared and analyzed by using the Simulink simulation platform.Finally,the actual test was carried out by building a test platform for heavy-duty industrial robots.The test results show that the peak suppression rates of ZV and EI input shapers are 31.25%and 41.02%,respectively,which verifies the effective-ness of the input shaping suppression method based on electromechanical coupling analysis in suppressing the residual vibration at the end of heavy-duty industrial robots.
王盛学;熊晋锋;赵阳;范思怡
重庆文理学院智能制造工程学院,重庆 402160||重庆城市职业学院信息与智能制造学院,重庆 402160重庆文理学院智能制造工程学院,重庆 402160重庆文理学院智能制造工程学院,重庆 402160重庆文理学院智能制造工程学院,重庆 402160
信息技术与安全科学
重载工业机器人机电耦合残余振动输入整形
heavy-duty industrial robotselectromechanical couplingresidual vibrationsenter shaping
《现代制造工程》 2026 (8)
43-49,7
重庆市自然科学基金创新项目(CSTB2024NSCQ-LZX0128)重庆文理学院研究生科研创新项目(CUAS-GSG2024004)
评论