稀土Pr对800MPa级高强钢焊接熔敷金属组织和性能的影响OA
Influence of Rare Earth Pr on Microstructure and Properties of Weld Deposited Metal of 800 MPa Grade High-Strength Steel
以800 MPa级高强钢焊接熔敷金属为研究对象,采用自制金属粉芯焊丝(⌀1.2 mm)进行多层多道焊,分别制备不含Pr6O11、含1%Pr6O11和含2%Pr6O11熔敷金属试样.利用高温激光扫描共聚焦显微镜对奥氏体、针状铁素体、上贝氏体及马氏体的形成过程进行原位观察,结合SEM-EDS微观组织表征与力学性能测试,研究了稀土Pr6O11对熔敷金属组织及性能的影响.结果表明:未添加Pr6O11时,夹杂物在晶界处聚集,奥氏体晶粒平均尺寸为129 μm,上贝氏体体积分数最高达46%,冲击韧性为45 J;添加1%Pr6O11后,夹杂物细化并在晶内弥散分布,奥氏体晶粒细化至41 μm,针状铁素体体积分数升至52%,抗拉强度达834 MPa,冲击韧性提高至72 J;添加2%Pr6O11后,夹杂物数量减少,上贝氏体和马氏体含量增多,冲击韧性降低至61 J.研究表明,Pr6O11的最佳添加量为1%,可为800 MPa级高强钢焊接材料的成分优化提供参考.
The effects of rare earth praseodymium(Pr)on the growth behavior of austenite,ferrite,bainite and martensite as well as inclusion nucleation in the microstructure of weld deposited metal of 800 MPa grade high-strength steel were investi-gated via in-situ observation,and the correlations among chemical composition,microstructure and mechanical properties were systematically characterized.The results show that the weld metal without Pr6O11 addition exhibits coarsened austenite grains,with inclusions segregated at grain boundaries.Upper bainite nucleates and grows along grain boundaries,which hin-ders the growth of acicular ferrite,leading to the lowest impact toughness of 44 J for the deposited metal.The addition of 1%Pr6O11 facilitates the refinement and spheroidization of inclusions and austenite grains in deposited metal.Acicular ferrite preferentially nucleates and grows inside austenite grains to partition the original austenite matrix,restraining the formation and growth of upper bainite and martensite,thereby generating a multiphase partitioned microstructure,and the optimal im-pact toughness reaches 72 J.When the addition amount of Pr6O11 rises to 2%,excessive rare earth elements reduce the oxy-gen content within inclusions and decrease the number of nucleation sites for acicular ferrite.The volume fractions of upper bainite and martensite increase correspondingly,which deteriorates the mechanical properties of deposited metal and reduces the impact toughness to 61 J.
石雨龙;张天理;方乃文;王伟光;刘淇;李伟;马青军;信国松
上海工程技术大学 材料科学与工程学院,上海 201620上海工程技术大学 材料科学与工程学院,上海 201620中焊科技发展(哈尔滨)有限公司,哈尔滨 150077上海工程技术大学 材料科学与工程学院,上海 201620上海工程技术大学 材料科学与工程学院,上海 201620北京金威焊材有限公司,天津 301914天津市特种设备监督检验技术研究院,天津 300192聚力新材料科技(日照)有限公司,山东 日照 276800
矿业与冶金
高强钢Pr6O11熔敷金属微观组织力学性能原位观察
high-strength steelPr6O11weld deposited metalmicrostructuremechanical propertyin-situ observation
《电焊机》 2026 (8)
80-88,9
泰山产业领军人才工程(2024001)国家自然科学基金项目(51804196)
评论