水性环氧树脂含量对微表处混合料性能的影响OA
Influence of Waterborne Epoxy Resin Content on the Performance of Micro-surfacing Mixtures
为研究水性环氧树脂(WER)含量对微表处混合料路用性能的影响,文中设计了不同水性环氧树脂含量的改性乳化沥青,并制备了相应的微表处混合料和对照组混合料(4%SBR 改性乳化沥青微表处混合料),通过抗滑性能测试、肯塔堡飞散试验、湿轮磨耗试验和加速加载试验,对比分析不同混合料的防滑性、黏结性和耐磨性.结果表明,摆式摩擦系数值随 WER 含量的增加先增加后减少,在 WER 含量为8%~11%时达到最大值;肯塔堡飞散损失量随 WER 含量的增加先降低后增加,在8%~11%时最小;湿路磨损损失值随 WER 含量的增加整体呈下降趋势;加速加载试验中,11%WER 混合料试样的摆式摩擦系数值、构造深度和质量损失变化最小.推荐最佳 WER 含量为乳化沥青重量比例的11%,可为水性环氧树脂改性乳化沥青在微表处中的应用提供参考.
In order to investigate the influence of waterborne epoxy resin(WER)content on the road performance of micro-surfacing mixtures,modified emulsified asphalt with different WER contents was designed,and corresponding micro-surfacing mixtures along with a control group mixture(4%SBR-modified emulsified asphalt micro-surfacing mixture)were prepared.Through skid resistance tests,Cantabro loss tests,wet wheel abrasion tests,and accelerated loading tests,the skid resistance,adhesive properties,and wear resistance of the different mixtures were comparatively analyzed.The results show that the pendulum friction coefficient value initially increases and then decreases with increasing WER content,reaching its maximum within the WER content range of 8%to 11%.The Cantabro loss first decreases and then increases with rising WER content,reaching its lowest value at 8%to 11%.The wet track abrasion loss value shows an overall decreasing trend with increasing WER dosage.In the accelerated loading tests,the micro-surfacing mixture sample with 11%WER exhibited the smallest changes in pendulum friction coefficient value,texture depth,and mass loss.The recommended optimal WER content is 11%of the emulsified asphalt weight.The research findings are expected to provide guidance for the application of waterborne epoxy resin emulsified asphalt in micro-surfacing mixtures.
柴显文;张泽
安顺公路建设养护有限公司,贵州 安顺 550081安顺公路建设养护有限公司,贵州 安顺 550081
交通工程
微表处水性环氧树脂防滑性黏结性耐磨性
Micro-surfacingWaterborne epoxy resinSkid resistanceAdhesionWear resistance
《江西建材》 2026 (4)
95-99,5
评论