Numerical and experimental studies of the natural mixing behavior between an uncemented paste backfill and dumped waste rock in stopes from laboratory toward field conditions.Part I:Calibration and validation of a numerical modelOA
Underground mining operations generate large volumes of waste rock(WR).Transporting this material to the surface requires significant energy and incurs operational costs.As an alternative,WR can be directly dumped into stopes being filled with cemented paste backfill(CPB),reducing both costs and greenhouse gas emissions.However,inadequate dumping may lead to poor mixing between cohesionless WR and CPB,resulting in fill mass collapse during or after adjacent stope excavation.Understanding and quantifying the natural mixing between dumped WR and CPB is therefore critical;yet,such studies are scarce.A major challenge lies in replicating large-scale field behavior through limited laboratory-scale tests using scalped(truncated)WR samples.Numerical modeling becomes essential to capture size effects related to both stope and WR particle sizes.In this study,a discrete element method(DEM)-based numerical model was employed.It was first calibrated using repose angle tests on WR samples with varying maximum particle sizes(dmax),prepared using the scalping-down technique.All model parameters were determined through direct measurements,except for the rolling resistance coefficient(µr)between WR particles,which should be obtained through numerical calibration.Initially,it was assumed that theµr would vary with dmax,in line with the observed increase in repose angle with larger dmax.Surprisingly,calibration showed thatµr was not very sensitive to changes in dmax,contradicting the experimental trend.Further investigation revealed that repose angle measurements are influenced by the quantity of material used;when sufficient WR mass is employed,the repose angle also becomes independent of dmax.This confirms that scalped samples can reliably represent in situ WR in repose angle tests.The scalping technique is thus validated for use in laboratory piles tests.The predictive capability of the calibrated model is further supported by strong agreement with additional experimental data.This calibrated and validated numerical DEM model can now be confidently applied to analyze the mechanical behavior of WR-based infrastructures across varying particle sizes and field conditions.Its application to simulate the natural mixing between dumped WR and uncemented paste backfill is presented in Part II of this companion study.
Yuyu Zhang;Li Li;Serge Ouellet;Louis-Philippe Gélinas
Research Institute of Mines and Environment(RIME UQAT-Polytechnique),Department of Civil,Geological and Mining Engineering,Polytechnique Montréal,C.P.6079,Succursale Centre-Ville,Montréal,Québec H3C 3A7,CanadaResearch Institute of Mines and Environment(RIME UQAT-Polytechnique),Department of Civil,Geological and Mining Engineering,Polytechnique Montréal,C.P.6079,Succursale Centre-Ville,Montréal,Québec H3C 3A7,CanadaAgnico Eagle Mines Limited,100,chemin du Lac Mourier,Malartic,Québec J0Y 1Z0,CanadaAgnico Eagle Mines Limited,CSD,10200,route de Preissac,Rouyn-Noranda,QC J0Y 1C0,Canada
矿业与冶金
Waste rocksPaste backfillNatural mixing behaviorRepose angleScalping methodRolling resistance coefficientNumerical modelingReliability
《Deep Resources Engineering》 2026 (1)
P.1-10,10
support from the Natural Sciences and Engineering Research Council of Canada(NSERC RGPIN-2024-06859)Natural Sciences and Engineering Research Council of Canada(NSERC ALLRP 580767-22)。
评论