喷雾冷却式湿蒸汽装置蒸汽流动参数的预测OA
Prediction of Steam Flow Parameters in Spray Cooled Wet Steam Device
针对喷雾冷却式湿蒸汽流量标准装置的结构特点,推导得出目前研究中常用的焓守恒方程成立的假设条件,并在此基础上通过提出其他假设条件引入动能方程,从而建立装置流动参数的数学模型,模型能够在已知装置入口过热蒸汽和冷却水参数的条件下,预测装置出口混合蒸汽的参数.在实验验证的工况范围内,压力、温度和干度的最大预测相对误差分别为5.35%、2.3%和-0.48%,当干度大于0.9时,压力和温度的预测误差均在±2%以内,预测误差随干度的降低而增大.
Taking into account the structural features of the spray cooled wet steam flow standard device,the assumptions necessary for the commonly used enthalpy conservation equation in current researches is derived,and on this basis,other assumptions are introduced to introduce the kinetic energy equation,thus establishing a mathematical model for the flow parameters of the device.The model can predict the parameters of the mixed steam exiting the device under the condition that the inlet superheated steam and cooling water parameters are known.In the experimental verification conditions,the maximum relative errors of pressure,temperature,and dryness are 5.35%,2.3%,and-0.48%,respectively.When the dryness is greater than 0.9,the prediction errors of pressure and temperature are both within±2%.The prediction error increases as the dryness decreases.
李涛;张涛;于洪仕;徐英;李宝;袁超;艾克拜尔·麦麦提
天津大学 电气自动化与信息工程学院,天津 300072||天津市过程检测与控制重点实验室,天津 300072天津大学 电气自动化与信息工程学院,天津 300072||天津市过程检测与控制重点实验室,天津 300072辽宁工程技术大学,辽宁 阜新 125105天津大学 电气自动化与信息工程学院,天津 300072||天津市过程检测与控制重点实验室,天津 300072国家蒸汽流量计量站,山东 烟台 264000天津大学 电气自动化与信息工程学院,天津 300072||天津市过程检测与控制重点实验室,天津 300072新疆维吾尔自治区计量测试研究院,新疆 乌鲁木齐 830011
通用工业技术
流量测量流动参数预测标准装置湿蒸汽饱和蒸汽喷雾冷却焓动能
flow measurementflow parameter predictionstandard devicewet steamsaturated steamspray cooledenthalpykinetic energy
《计量学报》 2026 (3)
349-355,7
国家自然科学基金(62071321)
评论