综合优化模型下无人机单轴姿态优化与精度分析OA
Optimization and accuracy analysis of single-axis attitude for UAV under a comprehensive optimization model
随着无人机技术的发展,其在测量和测绘领域中的应用日益广泛.本文提出了一种综合优化模型,旨在确定无人机测量任务中的最优单轴姿态.模型通过调整6种测量姿态,计算绕扭摆轴旋转的惯量,并推导惯性积,进而构建转动惯量求解公式.在小偏移角条件下,研究了最佳单轴测量方式以实现最小化测量误差.仿真和实地测试结果验证了模型的有效性,结果表明该方法显著提高了测量精度,降低了操作复杂度和成本.此外,为提升测量精度,提出了基于蒙特卡洛算法的优化技术,分别在无约束和有约束条件下确定最优测量姿态.模拟结果显示,当随机误差控制在1%以内时,相对误差<0.5%,验证了姿态角度选择对测量精度的关键作用.
With the development of UAV technology,its application in the field of surveying and mapping has become increasingly widespread.This paper proposed a comprehensive optimization model aimed at de-termining the optimal single-axis attitude in UAV surveying tasks.The model calculated the moment of in-ertia around the torsion axis by adjusting six measurement attitudes,derived the inertia product,and then constructed a formula for solving the moment of inertia.Under the condition of small offset angles,the op-timal single-axis measurement method was studied to achieve the minimization of measurement error.Sim-ulation and field test results verify the effectiveness of the model,showing that this method significantly improves measurement accuracy and reduces operational complexity and cost.Furthermore,to enhance measurement accuracy,an optimization technique based on the Monte Carlo algorithm was proposed to de-termine the optimal measurement attitude under both unconstrained and constrained conditions.Simulation results show that when the random error is controlled within 1%,the relative error is less than 0.5%,veri-fying the crucial role of attitude angle selection in measurement accuracy.
李圳峰;李傲质;孙立伟
中国人民解放军63969部队,江苏 南京,211100长春理工大学 机电工程学院,吉林 长春 130022长春理工大学 机电工程学院,吉林 长春 130022
矿业与冶金
无人机最优姿态测量精度随机误差分析
UAVoptimal attitudemeasurement accuracyrandom error analysis
《长春工程学院学报(自然科学版)》 2026 (1)
84-92,9
吉林省科技发展计划项目(20210201057GX)
评论